diff options
Diffstat (limited to 'nixos/doc/manual/from_md')
-rw-r--r-- | nixos/doc/manual/from_md/administration/container-networking.section.xml | 54 |
1 files changed, 54 insertions, 0 deletions
diff --git a/nixos/doc/manual/from_md/administration/container-networking.section.xml b/nixos/doc/manual/from_md/administration/container-networking.section.xml new file mode 100644 index 000000000000..788a2b7b0acb --- /dev/null +++ b/nixos/doc/manual/from_md/administration/container-networking.section.xml @@ -0,0 +1,54 @@ +<section xmlns="http://docbook.org/ns/docbook" xmlns:xlink="http://www.w3.org/1999/xlink" xml:id="sec-container-networking"> + <title>Container Networking</title> + <para> + When you create a container using + <literal>nixos-container create</literal>, it gets it own private + IPv4 address in the range <literal>10.233.0.0/16</literal>. You can + get the container’s IPv4 address as follows: + </para> + <programlisting> +# nixos-container show-ip foo +10.233.4.2 + +$ ping -c1 10.233.4.2 +64 bytes from 10.233.4.2: icmp_seq=1 ttl=64 time=0.106 ms +</programlisting> + <para> + Networking is implemented using a pair of virtual Ethernet devices. + The network interface in the container is called + <literal>eth0</literal>, while the matching interface in the host is + called <literal>ve-container-name</literal> (e.g., + <literal>ve-foo</literal>). The container has its own network + namespace and the <literal>CAP_NET_ADMIN</literal> capability, so it + can perform arbitrary network configuration such as setting up + firewall rules, without affecting or having access to the host’s + network. + </para> + <para> + By default, containers cannot talk to the outside network. If you + want that, you should set up Network Address Translation (NAT) rules + on the host to rewrite container traffic to use your external IP + address. This can be accomplished using the following configuration + on the host: + </para> + <programlisting language="bash"> +networking.nat.enable = true; +networking.nat.internalInterfaces = ["ve-+"]; +networking.nat.externalInterface = "eth0"; +</programlisting> + <para> + where <literal>eth0</literal> should be replaced with the desired + external interface. Note that <literal>ve-+</literal> is a wildcard + that matches all container interfaces. + </para> + <para> + If you are using Network Manager, you need to explicitly prevent it + from managing container interfaces: + </para> + <programlisting language="bash"> +networking.networkmanager.unmanaged = [ "interface-name:ve-*" ]; +</programlisting> + <para> + You may need to restart your system for the changes to take effect. + </para> +</section> |