#
# RTC class/drivers configuration
#
config RTC_LIB
bool
menuconfig RTC_CLASS
bool "Real Time Clock"
default n
depends on !S390 && !UML
select RTC_LIB
help
Generic RTC class support. If you say yes here, you will
be allowed to plug one or more RTCs to your system. You will
probably want to enable one or more of the interfaces below.
if RTC_CLASS
config RTC_HCTOSYS
bool "Set system time from RTC on startup and resume"
default y
help
If you say yes here, the system time (wall clock) will be set using
the value read from a specified RTC device. This is useful to avoid
unnecessary fsck runs at boot time, and to network better.
config RTC_SYSTOHC
bool "Set the RTC time based on NTP synchronization"
default y
help
If you say yes here, the system time (wall clock) will be stored
in the RTC specified by RTC_HCTOSYS_DEVICE approximately every 11
minutes if userspace reports synchronized NTP status.
config RTC_HCTOSYS_DEVICE
string "RTC used to set the system time"
depends on RTC_HCTOSYS = y || RTC_SYSTOHC = y
default "rtc0"
help
The RTC device that will be used to (re)initialize the system
clock, usually rtc0. Initialization is done when the system
starts up, and when it resumes from a low power state. This
device should record time in UTC, since the kernel won't do