1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
284
285
286
287
288
289
290
291
292
293
294
295
296
297
298
299
300
301
302
303
304
305
306
307
308
309
310
311
312
313
314
315
316
317
318
319
320
321
322
323
324
325
326
327
328
329
330
331
332
333
334
335
336
337
338
339
340
341
342
343
344
345
346
347
348
349
350
351
352
353
354
355
356
357
358
|
/*
* ECAP PWM driver
*
* Copyright (C) 2012 Texas Instruments, Inc. - http://www.ti.com/
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; either version 2 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program; if not, write to the Free Software
* Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
*/
#include <linux/module.h>
#include <linux/platform_device.h>
#include <linux/io.h>
#include <linux/err.h>
#include <linux/clk.h>
#include <linux/pm_runtime.h>
#include <linux/pwm.h>
#include <linux/of_device.h>
#include <linux/pinctrl/consumer.h>
#include "pwm-tipwmss.h"
/* ECAP registers and bits definitions */
#define CAP1 0x08
#define CAP2 0x0C
#define CAP3 0x10
#define CAP4 0x14
#define ECCTL2 0x2A
#define ECCTL2_APWM_POL_LOW BIT(10)
#define ECCTL2_APWM_MODE BIT(9)
#define ECCTL2_SYNC_SEL_DISA (BIT(7) | BIT(6))
#define ECCTL2_TSCTR_FREERUN BIT(4)
struct ecap_context {
u32 cap3;
u32 cap4;
u16 ecctl2;
};
struct ecap_pwm_chip {
struct pwm_chip chip;
unsigned int clk_rate;
void __iomem *mmio_base;
struct ecap_context ctx;
};
static inline struct ecap_pwm_chip *to_ecap_pwm_chip(struct pwm_chip *chip)
{
return container_of(chip, struct ecap_pwm_chip, chip);
}
/*
* period_ns = 10^9 * period_cycles / PWM_CLK_RATE
* duty_ns = 10^9 * duty_cycles / PWM_CLK_RATE
*/
static int ecap_pwm_config(struct pwm_chip *chip, struct pwm_device *pwm,
int duty_ns, int period_ns)
{
struct ecap_pwm_chip *pc = to_ecap_pwm_chip(chip);
unsigned long long c;
unsigned long period_cycles, duty_cycles;
unsigned int reg_val;
if (period_ns > NSEC_PER_SEC)
return -ERANGE;
c = pc->clk_rate;
c = c * period_ns;
do_div(c, NSEC_PER_SEC);
period_cycles = (unsigned long)c;
if (period_cycles < 1) {
period_cycles = 1;
duty_cycles = 1;
} else {
c = pc->clk_rate;
c = c * duty_ns;
do_div(c, NSEC_PER_SEC);
duty_cycles = (unsigned long)c;
}
pm_runtime_get_sync(pc->chip.dev);
reg_val = readw(pc->mmio_base + ECCTL2);
/* Configure APWM mode & disable sync option */
reg_val |= ECCTL2_APWM_MODE | ECCTL2_SYNC_SEL_DISA;
writew(reg_val, pc->mmio_base + ECCTL2);
if (!test_bit(PWMF_ENABLED, &pwm->flags)) {
/* Update active registers if not running */
writel(duty_cycles, pc->mmio_base + CAP2);
writel(period_cycles, pc->mmio_base + CAP1);
} else {
/*
* Update shadow registers to configure period and
* compare values. This helps current PWM period to
* complete on reconfiguring
*/
writel(duty_cycles, pc->mmio_base + CAP4);
writel(period_cycles, pc->mmio_base + CAP3);
}
if (!test_bit(PWMF_ENABLED, &pwm->flags)) {
reg_val = readw(pc->mmio_base + ECCTL2);
/* Disable APWM mode to put APWM output Low */
reg_val &= ~ECCTL2_APWM_MODE;
writew(reg_val, pc->mmio_base + ECCTL2);
}
pm_runtime_put_sync(pc->chip.dev);
return 0;
}
static int ecap_pwm_set_polarity(struct pwm_chip *chip, struct pwm_device *pwm,
enum pwm_polarity polarity)
{
struct ecap_pwm_chip *pc = to_ecap_pwm_chip(chip);
unsigned short reg_val;
pm_runtime_get_sync(pc->chip.dev);
reg_val = readw(pc->mmio_base + ECCTL2);
if (polarity == PWM_POLARITY_INVERSED)
/* Duty cycle defines LOW period of PWM */
reg_val |= ECCTL2_APWM_POL_LOW;
else
/* Duty cycle defines HIGH period of PWM */
reg_val &= ~ECCTL2_APWM_POL_LOW;
writew(reg_val, pc->mmio_base + ECCTL2);
pm_runtime_put_sync(pc->chip.dev);
return 0;
}
static int ecap_pwm_enable(struct pwm_chip *chip, struct pwm_device *pwm)
{
struct ecap_pwm_chip *pc = to_ecap_pwm_chip(chip);
unsigned int reg_val;
/* Leave clock enabled on enabling PWM */
pm_runtime_get_sync(pc->chip.dev);
/*
* Enable 'Free run Time stamp counter mode' to start counter
* and 'APWM mode' to enable APWM output
*/
reg_val = readw(pc->mmio_base + ECCTL2);
reg_val |= ECCTL2_TSCTR_FREERUN | ECCTL2_APWM_MODE;
writew(reg_val, pc->mmio_base + ECCTL2);
return 0;
}
static void ecap_pwm_disable(struct pwm_chip *chip, struct pwm_device *pwm)
{
struct ecap_pwm_chip *pc = to_ecap_pwm_chip(chip);
unsigned int reg_val;
/*
* Disable 'Free run Time stamp counter mode' to stop counter
* and 'APWM mode' to put APWM output to low
*/
reg_val = readw(pc->mmio_base + ECCTL2);
reg_val &= ~(ECCTL2_TSCTR_FREERUN | ECCTL2_APWM_MODE);
writew(reg_val, pc->mmio_base + ECCTL2);
/* Disable clock on PWM disable */
pm_runtime_put_sync(pc->chip.dev);
}
static void ecap_pwm_free(struct pwm_chip *chip, struct pwm_device *pwm)
{
if (test_bit(PWMF_ENABLED, &pwm->flags)) {
dev_warn(chip->dev, "Removing PWM device without disabling\n");
pm_runtime_put_sync(chip->dev);
}
}
static const struct pwm_ops ecap_pwm_ops = {
.free = ecap_pwm_free,
.config = ecap_pwm_config,
.set_polarity = ecap_pwm_set_polarity,
.enable = ecap_pwm_enable,
.disable = ecap_pwm_disable,
.owner = THIS_MODULE,
};
static const struct of_device_id ecap_of_match[] = {
{ .compatible = "ti,am33xx-ecap" },
{},
};
MODULE_DEVICE_TABLE(of, ecap_of_match);
static int ecap_pwm_probe(struct platform_device *pdev)
{
int ret;
struct resource *r;
struct clk *clk;
struct ecap_pwm_chip *pc;
u16 status;
struct pinctrl *pinctrl;
pinctrl = devm_pinctrl_get_select_default(&pdev->dev);
if (IS_ERR(pinctrl))
dev_warn(&pdev->dev, "unable to select pin group\n");
pc = devm_kzalloc(&pdev->dev, sizeof(*pc), GFP_KERNEL);
if (!pc) {
dev_err(&pdev->dev, "failed to allocate memory\n");
return -ENOMEM;
}
clk = devm_clk_get(&pdev->dev, "fck");
if (IS_ERR(clk)) {
dev_err(&pdev->dev, "failed to get clock\n");
return PTR_ERR(clk);
}
pc->clk_rate = clk_get_rate(clk);
if (!pc->clk_rate) {
dev_err(&pdev->dev, "failed to get clock rate\n");
return -EINVAL;
}
pc->chip.dev = &pdev->dev;
pc->chip.ops = &ecap_pwm_ops;
pc->chip.of_xlate = of_pwm_xlate_with_flags;
pc->chip.of_pwm_n_cells = 3;
pc->chip.base = -1;
pc->chip.npwm = 1;
r = platform_get_resource(pdev, IORESOURCE_MEM, 0);
if (!r) {
dev_err(&pdev->dev, "no memory resource defined\n");
return -ENODEV;
}
pc->mmio_base = devm_ioremap_resource(&pdev->dev, r);
if (IS_ERR(pc->mmio_base))
return PTR_ERR(pc->mmio_base);
ret = pwmchip_add(&pc->chip);
if (ret < 0) {
dev_err(&pdev->dev, "pwmchip_add() failed: %d\n", ret);
return ret;
}
pm_runtime_enable(&pdev->dev);
pm_runtime_get_sync(&pdev->dev);
status = pwmss_submodule_state_change(pdev->dev.parent,
PWMSS_ECAPCLK_EN);
if (!(status & PWMSS_ECAPCLK_EN_ACK)) {
dev_err(&pdev->dev, "PWMSS config space clock enable failed\n");
ret = -EINVAL;
goto pwmss_clk_failure;
}
pm_runtime_put_sync(&pdev->dev);
platform_set_drvdata(pdev, pc);
return 0;
pwmss_clk_failure:
pm_runtime_put_sync(&pdev->dev);
pm_runtime_disable(&pdev->dev);
pwmchip_remove
|