1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
|
// SPDX-License-Identifier: GPL-2.0-or-later
/*
Copyright (C) 2004 - 2009 Ivo van Doorn <IvDoorn@gmail.com>
<http://rt2x00.serialmonkey.com>
*/
/*
Module: rt2x00lib
Abstract: rt2x00 generic configuration routines.
*/
#include <linux/kernel.h>
#include <linux/module.h>
#include "rt2x00.h"
#include "rt2x00lib.h"
void rt2x00lib_config_intf(struct rt2x00_dev *rt2x00dev,
struct rt2x00_intf *intf,
enum nl80211_iftype type,
const u8 *mac, const u8 *bssid)
{
struct rt2x00intf_conf conf;
unsigned int flags = 0;
conf.type = type;
switch (type) {
case NL80211_IFTYPE_ADHOC:
conf.sync = TSF_SYNC_ADHOC;
break;
case NL80211_IFTYPE_AP:
case NL80211_IFTYPE_MESH_POINT:
conf.sync = TSF_SYNC_AP_NONE;
break;
case NL80211_IFTYPE_STATION:
conf.sync = TSF_SYNC_INFRA;
break;
default:
conf.sync = TSF_SYNC_NONE;
break;
}
/*
* Note that when NULL is passed as address we will send
* 00:00:00:00:00 to the device to clear the address.
* This will prevent the device being confused when it wants
* to ACK frames or considers itself associated.
*/
memset(conf.mac, 0, sizeof(conf.mac));
if (mac)
memcpy(conf.mac, mac, ETH_ALEN);
memset(conf.bssid, 0, sizeof(conf.bssid));
if (bssid)
memcpy(conf.bssid, bssid, ETH_ALEN);
flags |= CONFIG_UPDATE_TYPE;
if (mac || (!rt2x00dev->intf_ap_count && !rt2x00dev->intf_sta_count))
flags |= CONFIG_UPDATE_MAC;
if (bssid || (!rt2x00dev->intf_ap_count && !rt2x00dev->intf_sta_count))
flags |= CONFIG_UPDATE_BSSID;
rt2x00dev->ops->lib->config_intf(rt2x00dev, intf, &conf, flags);
}
void rt2x00lib_config_erp(struct rt2x00_dev *rt2x00dev,
struct rt2x00_intf *intf,
struct ieee80211_bss_conf *bss_conf,
u32 changed)
{
struct rt2x00lib_erp erp;
memset(&erp, 0, sizeof(erp));
erp.short_preamble = bss_conf->use_short_preamble;
erp.cts_protection = bss_conf->use_cts_prot;
erp.slot_time = bss_conf->use_short_slot ? SHORT_SLOT_TIME : SLOT_TIME;
erp.sifs = SIFS;
erp.pifs = bss_conf->use_short_slot ? SHORT_PIFS : PIFS;
erp.difs = bss_conf->use_short_slot ? SHORT_DIFS : DIFS;
erp.eifs = bss_conf->use_short_slot ? SHORT_EIFS : EIFS;
erp.basic_rates = bss_conf->basic_rates;
erp.beacon_int = bss_conf->beacon_int;
/* Update the AID, this is needed for dynamic PS support */
rt2x00dev->aid = bss_conf->assoc ? bss_conf->aid : 0;
rt2x00dev->last_beacon = bss_conf->sync_tsf;
/* Update global beacon interval time, this is needed for PS support */
rt2x00dev->beacon_int = bss_conf->beacon_int;
if (changed & BSS_CHANGED_HT)
erp.ht_opmode = bss_conf->ht_operation_mode;
rt2x00dev->ops->lib->config_erp(rt2x00dev, &erp, changed);
}
void rt2x00lib_config_antenna(struct rt2x00_dev *rt2x00dev,
struct antenna_setup config)
{
struct link_ant *ant = &rt2x00dev->link.ant;
struct antenna_setup *def = &rt2x00dev->default_ant;
struct antenna_setup *active = &rt2x00dev->link.ant.active;
/*
* When the caller tries to send the SW diversity,
* we must update the ANTENNA_RX_DIVERSITY flag to
* enable the antenna diversity in the link tuner.
*
* Secondly, we must guarentee we never send the
* software antenna diversity command to the driver.
*/
if (!(ant->flags & ANTENNA_RX_DIVERSITY)) {
if (config.rx == ANTENNA_SW_DIVERSITY) {
ant->flags |= ANTENNA_RX_DIVERSITY;
if (def->rx == ANTENNA_SW_DIVERSITY)
config.rx = ANTENNA_B;
else
config.rx = def->rx;
}
} else if (config.rx == ANTENNA_SW_DIVERSITY)
config.rx = active->rx;
if (!(ant->flags & ANTENNA_TX_DIVERSITY)) {
if (config.tx == ANTENNA_SW_DIVERSITY) {
ant->flags |= ANTENNA_TX_DIVERSITY;
if (def->tx == ANTENNA_SW_DIVERSITY)
config.tx = ANTENNA_B;
else
config.tx = def->tx;
}
} else if (config.tx == ANTENNA_SW_DIVERSITY)
config.tx = active->tx;
/*
* Antenna setup changes require the RX to be disabled,
* else the changes will be ignored by the device.
*/
if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags))
rt2x00queue_stop_queue(rt2x00dev->rx);
/*
* Write new antenna setup to device and reset the link tuner.
* The latter is required since we need to recalibrate the
* noise-sensitivity ratio for the new setup.
*/
rt2x00dev->ops->lib->config_ant(rt2x00dev, &config);
rt2x00link_reset_tuner(rt2x00dev, true);
memcpy(active, &config, sizeof(config));
if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags))
rt2x00queue_start_queue(rt2x00dev->rx);
}
static u16 rt2x00ht_center_channel(struct rt2x00_dev *rt2x00dev,
struct ieee80211_conf *conf)
{
struct hw_mode_spec *spec = &rt2x00dev->spec;
int center_channel;
u16 i;
/*
* Initialize center channel to current channel.
*/
center_channel = spec->channels[conf->chandef.chan->hw_value].channel;
/*
* Adjust center channel to HT40+ and HT40- operation.
*/
if (conf_is_ht40_plus(conf))
center_channel += 2;
else if (conf_is_ht40_minus(conf))
center_channel -= (center_channel == 14) ? 1 : 2;
for (i = 0; i < spec->num_channels; i++)
if (spec->channels[i].channel == center_channel)
return i;
WARN_ON(1);
return conf->chandef.chan->hw_value;
}
void rt2x00lib_config(struct rt2x00_dev *rt2x00dev,
struct ieee80211_conf *conf,
unsigned int ieee80211_flags)
{
struct rt2x00lib_conf libconf;
u16 hw_value;
u16 autowake_timeout;
u16 beacon_int;
u16 beacon_diff;
memset(&libconf, 0, sizeof(libconf));
libconf.conf = conf;
if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL) {
if (!conf_is_ht(conf))
set_bit(CONFIG_HT_DISABLED, &rt2x00dev->flags);
else
clear_bit(CONFIG_HT_DISABLED, &rt2x00dev->flags);
if (conf_is_ht40(conf)) {
set_bit(CONFIG_CHANNEL_HT40, &rt2x00dev->flags);
hw_value = rt2x00ht_center_channel(rt2x00dev, conf);
} else {
clear_bit(CONFIG_CHANNEL_HT40, &rt2x00dev->flags);
hw_value = conf->chandef.chan->hw_value;
}
memcpy(&libconf.rf,
&rt2x00dev->spec.channels[hw_value],
sizeof(libconf.rf));
memcpy(&libconf.channel,
&rt2x00dev->spec.channels_info[hw_value],
sizeof(libconf.channel));
/* Used for VCO periodic calibration */
rt2x00dev->rf_channel = libconf.rf.channel;
}
if (rt2x00_has_cap_flag(rt2x00dev, REQUIRE_PS_AUTOWAKE) &&
(ieee80211_flags & IEEE80211_CONF_CHANGE_PS))
cancel_delayed_work_sync(&rt2x00dev->autowakeup_work);
/*
* Start configuration.
*/
rt2x00dev->ops->lib->config(rt2x00dev, &libconf, ieee80211_flags);
if (conf->flags & IEEE80211_CONF_PS)
set_bit(CONFIG_POWERSAVING, &rt2x00dev->flags);
else
clear_bit(CONFIG_POWERSAVING, &rt2x00dev->flags);
if (conf->flags & IEEE80211_CONF_MONITOR)
set_bit(CONFIG_MONITORING, &rt2x00dev->flags);
else
clear_bit(CONFIG_MONITORING, &rt2x00dev->flags);
rt2x00dev->curr_band = conf->chandef.chan->band;
rt2x00dev->curr_freq = conf->chandef.chan->center_freq;
rt2x00dev->tx_power = conf->power_level;
rt2x00dev->short_retry = conf->short_frame_max_tx_count;
rt2x00dev->long_retry = conf->long_frame_max_tx_count;
/*
* Some configuration changes affect the link quality
* which means we need to reset the link tuner.
*/
if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL)
rt2x00link_reset_tuner(rt2x00dev, false);
if (test_bit(DEVICE_STATE_PRESENT, &rt2x00dev->flags) &&
rt2x00_has_cap_flag(rt2x00dev, REQUIRE_PS_AUTOWAKE) &&
(ieee80211_flags & IEEE80211_CONF_CHANGE_PS) &&
(conf->flags & IEEE80211_CONF_PS)) {
beacon_diff = (long)jiffies - (long)rt2x00dev->last_beacon;
beacon_int = msecs_to_jiffies(rt2x00dev->beacon_int);
if (beacon_diff > beacon_int)
beacon_diff =
|