#
# Network device configuration
#
config HAVE_NET_MACB
bool
menuconfig NETDEVICES
default y if UML
depends on NET
bool "Network device support"
---help---
You can say N here if you don't intend to connect your Linux box to
any other computer at all.
You'll have to say Y if your computer contains a network card that
you want to use under Linux. If you are going to run SLIP or PPP over
telephone line or null modem cable you need say Y here. Connecting
two machines with parallel ports using PLIP needs this, as well as
AX.25/KISS for sending Internet traffic over amateur radio links.
See also "The Linux Network Administrator's Guide" by Olaf Kirch and
Terry Dawson. Available at <http://www.tldp.org/guides.html>.
If unsure, say Y.
# All the following symbols are dependent on NETDEVICES - do not repeat
# that for each of the symbols.
if NETDEVICES
config IFB
tristate "Intermediate Functional Block support"
depends on NET_CLS_ACT
---help---
This is an intermediate driver that allows sharing of
resources.
To compile this driver as a module, choose M here: the module
will be called ifb. If you want to use more than one ifb
device at a time, you need to compile this driver as a module.
Instead of 'ifb', the devices will then be called 'ifb0',
'ifb1' etc.
Look at the iproute2 documentation directory for usage etc
config DUMMY
tristate "Dummy net driver support"
---help---
This is essentially a bit-bucket device (i.e. traffic you send to
this device is consigned into oblivion) with a configurable IP
address. It is most commonly used in order to make your currently
inactive SLIP address seem like a real address for local programs.
If you use SLIP or PPP, you might want to say Y here. Since this
thing often comes in handy, the default is Y. It won't enlarge your
kernel either. What a deal. Read about it in the Network
Administrator's Guide, available from
<http://www.tldp.org/docs.html#guide>.
To compile this driver as a module, choose M here: the module
will be called dummy. If you want to use more than one dummy
device at a time, you need to compile this driver as a module.
Instead of 'dummy', the devices will then be called 'dummy0',
'dummy1' etc.
config BONDING
tristate "Bonding driver support"
depends on INET
depends on IPV6 || IPV6=n
---help---
Say 'Y' or 'M' if you wish to be able to 'bond' multiple Ethernet
Channels together. This is called 'Etherchannel' by Cisco,
'Trunking' by Sun, 802.3ad by the IEEE, and 'Bonding' in Linux.
The driver supports multiple bonding modes to allow for both high
performance and high availability operation.
Refer to <file:Documentation/networking/bonding.txt> for more
information.
To compile this driver as a module, choose M here: the module
will be called bonding.
config MACVLAN
tristate "MAC-VLAN support (EXPERIMENTAL)"
depends on EXPERIMENTAL
---help---
This allows one to create virtual interfaces that map packets to
or from specific MAC addresses to a particular interface.
Macvlan devices can be added using the "ip" command from the
iproute2 package starting with the iproute2-2.6.23 release:
"ip link add link <real dev> [ address MAC ] [ NAME ] type macvlan"