// SPDX-License-Identifier: GPL-2.0-or-later
/*
* l1oip.c low level driver for tunneling layer 1 over IP
*
* NOTE: It is not compatible with TDMoIP nor "ISDN over IP".
*
* Author Andreas Eversberg (jolly@eversberg.eu)
*/
/* module parameters:
* type:
Value 1 = BRI
Value 2 = PRI
Value 3 = BRI (multi channel frame, not supported yet)
Value 4 = PRI (multi channel frame, not supported yet)
A multi channel frame reduces overhead to a single frame for all
b-channels, but increases delay.
(NOTE: Multi channel frames are not implemented yet.)
* codec:
Value 0 = transparent (default)
Value 1 = transfer ALAW
Value 2 = transfer ULAW
Value 3 = transfer generic 4 bit compression.
* ulaw:
0 = we use a-Law (default)
1 = we use u-Law
* limit:
limitation of B-channels to control bandwidth (1...126)
BRI: 1 or 2
PRI: 1-30, 31-126 (126, because dchannel ist not counted here)
Also limited ressources are used for stack, resulting in less channels.
It is possible to have more channels than 30 in PRI mode, this must
be supported by the application.
* ip:
byte representation of remote ip address (127.0.0.1 -> 127,0,0,1)
If not given or four 0, no remote address is set.
For multiple interfaces, concat ip addresses. (127,0,0,1,127,0,0,1)
* port:
port number (local interface)
If not given or 0, port 931 is used for fist instance, 932 for next...
For multiple interfaces, different ports must be given.
* remoteport:
port number (remote interface)
If not given or 0, remote port equals local port
For multiple interfaces on equal sites, different ports must be given.
* ondemand:
0 = fixed (always transmit packets, even when remote side timed out)
1 = on demand (only transmit packets, when remote side is detected)
the default is 0
NOTE: ID must also be set for on demand.
* id:
optional value to identify frames. This value must be equal on both
peers and should be random. If omitted or 0, no ID is transmitted.
* debug:
NOTE: only one debug value must be given for all cards
enable debugging (see l1oip.h for debug options)
Special mISDN controls:
op = MISDN_CTRL_SETPEER*
p1 = bytes 0-3 : remote IP address in network order (left element first)
p2 = bytes 1-2 : remote port in network order (high byte first)
optional:
p2 = bytes 3-4 : local port in network order (high byte first)
op = MISDN_CTRL_UNSETPEER*
* Use l1oipctrl for comfortable setting or removing ip address.
(Layer 1 Over IP CTRL)
L1oIP-Protocol
--------------