// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright (C) 2002 Motorola GSG-China
*
* Author:
* Darius Augulis, Teltonika Inc.
*
* Desc.:
* Implementation of I2C Adapter/Algorithm Driver
* for I2C Bus integrated in Freescale i.MX/MXC processors
*
* Derived from Motorola GSG China I2C example driver
*
* Copyright (C) 2005 Torsten Koschorrek <koschorrek at synertronixx.de
* Copyright (C) 2005 Matthias Blaschke <blaschke at synertronixx.de
* Copyright (C) 2007 RightHand Technologies, Inc.
* Copyright (C) 2008 Darius Augulis <darius.augulis at teltonika.lt>
*
* Copyright 2013 Freescale Semiconductor, Inc.
*
*/
#include <linux/clk.h>
#include <linux/completion.h>
#include <linux/delay.h>
#include <linux/dma-mapping.h>
#include <linux/dmaengine.h>
#include <linux/dmapool.h>
#include <linux/err.h>
#include <linux/errno.h>
#include <linux/gpio/consumer.h>
#include <linux/i2c.h>
#include <linux/init.h>
#include <linux/interrupt.h>
#include <linux/io.h>
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/of.h>
#include <linux/of_device.h>
#include <linux/of_dma.h>
#include <linux/pinctrl/consumer.h>
#include <linux/platform_data/i2c-imx.h>
#include <linux/platform_device.h>
#include <linux/pm_runtime.h>
#include <linux/sched.h>
#include <linux/slab.h>
/* This will be the driver name the kernel reports */
#define DRIVER_NAME "imx-i2c"
/* Default value */
#define IMX_I2C_BIT_RATE 100000 /* 100kHz */
/*
* Enable DMA if transfer byte size is bigger than this threshold.
* As the hardware request, it must bigger than 4 bytes.\
* I have set '16' here, maybe it's not the best but I think it's
* the appropriate.
*/
#define DMA_THRESHOLD 16
#define DMA_TIMEOUT 1000
/* IMX I2C registers:
* the I2C register offset is different between SoCs,
* to provid support for all these chips, split the
* register offset into a fixed base address and a
* variable shift value, then the full register offset
* will be calculated by
* reg_off = ( reg_base_addr << reg_shift)
*/
#define IMX_I2C_IADR 0x00 /* i2c slave address */
#define IMX_I2C_IFDR 0x01 /* i2c frequency divider */
#define IMX_I2C_I2CR 0x02 /* i2c control */
#define IMX_I2C_I2SR 0x03 /* i2c status */
#define IMX_I2C_I2DR 0x04 /* i2c transfer data */
#define IMX_I2C_REGSHIFT 2
#define VF610_I2C_REGSHIFT 0
/* Bits of IMX I2C registers */
#define I2SR_RXAK 0x01
#define I2SR_IIF 0x02
#define I2SR_SRW 0x04
#define I2SR_IAL 0x10
#define I2SR_IBB 0x20
#define I2SR_IAAS 0x40
#define I2SR_ICF 0x80
#define I2CR_DMAEN 0x02
#define I2CR_RSTA 0x04
#define I2CR_TXAK 0x08
#define I2CR_MTX 0x10
#define I2CR_MSTA 0x20
#define I2CR_IIEN 0x40
#define I2CR_IEN 0x80
/* register bits different operating codes definition:
* 1) I2SR: Interrupt flags clear operation differ between SoCs:
* - write zero to clear(w0c) INT flag on i.MX,
* - but write one to clear(w1c) INT flag on Vybrid.
* 2) I2CR: I2C module enable operation also differ between SoCs:
* - set I2CR_IEN bit enable the module on i.MX,
* - but clear I2CR_IEN bit enable the module on Vybrid.
*/
#define I2SR_CLR_OPCODE_W0C 0x0
#define I2SR_CLR_OPCODE_W1C (I2SR_IAL | I2SR_IIF)
#define I2CR_IEN_OPCODE_0 0x0
#define I2CR_IEN_OPCODE_1 I2CR_IEN
#define I2C_PM_TIMEOUT 10 /* ms */
/*
* sorted list of clock divider, register value pairs
* taken from table 26-5, p.26-9, Freescale i.MX
* Integrated Portable System Processor Reference Manual
* Document Number: MC9328MXLRM, Rev. 5.1, 06/2007
*
* Duplicated divider values removed from list
*/
struct imx_i2c_clk_pair {
u16 div;
u16 val;
};
static struct imx_i2c_clk_pair imx_i2c_clk_div[] = {
{ 22, 0x20 }, { 24, 0x21 }, { 26, 0x22 }, { 28, 0x23 },
{ 30, 0x00 }, { 32, 0x24 }, { 36, 0x25 }, { 40, 0x26 },
{ 42, 0x03 }, { 44, 0x27 }, { 48, 0x28 }, { 52, 0x05 },
{ 56, 0x29 }, { 60, 0x06 }, { 64, 0x2A }, { 72, 0x2B },
{ 80, 0x2C }, { 88, 0x09 }, { 96, 0x2D }, { 104,