/*
* Copyright (C) 2005, 2006 IBM Corporation
* Copyright (C) 2014, 2015 Intel Corporation
*
* Authors:
* Leendert van Doorn <leendert@watson.ibm.com>
* Kylene Hall <kjhall@us.ibm.com>
*
* Maintained by: <tpmdd-devel@lists.sourceforge.net>
*
* Device driver for TCG/TCPA TPM (trusted platform module).
* Specifications at www.trustedcomputinggroup.org
*
* This device driver implements the TPM interface as defined in
* the TCG TPM Interface Spec version 1.2, revision 1.0.
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License as
* published by the Free Software Foundation, version 2 of the
* License.
*/
#include <linux/init.h>
#include <linux/module.h>
#include <linux/moduleparam.h>
#include <linux/pnp.h>
#include <linux/slab.h>
#include <linux/interrupt.h>
#include <linux/wait.h>
#include <linux/acpi.h>
#include <linux/freezer.h>
#include "tpm.h"
#include "tpm_tis_core.h"
enum tis_access {
TPM_ACCESS_VALID = 0x80,
TPM_ACCESS_ACTIVE_LOCALITY = 0x20,
TPM_ACCESS_REQUEST_PENDING = 0x04,
TPM_ACCESS_REQUEST_USE = 0x02,
};
enum tis_status {
TPM_STS_VALID = 0x80,
TPM_STS_COMMAND_READY = 0x40,
TPM_STS_GO = 0x20,
TPM_STS_DATA_AVAIL = 0x10,
TPM_STS_DATA_EXPECT = 0x08,
};
enum tis_int_flags {
TPM_GLOBAL_INT_ENABLE = 0x80000000,
TPM_INTF_BURST_COUNT_STATIC = 0x100,
TPM_INTF_CMD_READY_INT = 0x080,
TPM_INTF_INT_EDGE_FALLING = 0x040,
TPM_INTF_INT_EDGE_RISING = 0x020,
TPM_INTF_INT_LEVEL_LOW = 0x010,
TPM_INTF_INT_LEVEL_HIGH = 0x008,
TPM_INTF_LOCALITY_CHANGE_INT = 0x004,
TPM_INTF_STS_VALID_INT = 0x002,
TPM_INTF_DATA_AVAIL_INT = 0x001,
};
enum tis_defaults {
TIS_MEM_LEN = 0x5000,
TIS_SHORT_TIMEOUT = 750, /* ms */
TIS_LONG_TIMEOUT = 2000, /* 2 sec */
};
struct tpm_info {
struct resource res;
/* irq > 0 means: use irq $irq;
* irq = 0 means: autoprobe for an irq;
* irq = -1 means: no irq support
*/
int irq;
};
/* Some timeout values are needed before it is known whether the chip is
* TPM 1.0 or TPM 2.0.
*/
#define TIS_TIMEOUT_A_MAX max(TIS_SHORT_TIMEOUT, TPM2_TIMEOUT_A)
#define TIS_TIMEOUT_B_MAX max(TIS_LONG_TIMEOUT, TPM2_TIMEOUT_B)
#define TIS_TIMEOUT_C_MAX max(TIS_SHORT_TIMEOUT, TPM2_TIMEOUT_C)
#define TIS_TIMEOUT_D_MAX max(TIS_SHORT_TIMEOUT, TPM2_TIMEOUT_D)
#define TPM_ACCESS(l) (0x0000 | ((l) << 12))
#define TPM_INT_ENABLE(l) (0x0008 | ((l) << 12))
#define TPM_INT_VECTOR(l) (0x000C | ((l) << 12))
#define TPM_INT_STATUS(l) (0x0010 | ((l) << 12))
#define TPM_INTF_CAPS(l) (0x0014 | ((l) << 12))
#define TPM_STS(l) (0x0018 | ((l) << 12))
#define TPM_STS3(l) (0x001b | ((l) << 12))
#define TPM_DATA_FIFO(l) (0x0024 | ((l) << 12))
#define TPM_DID_VID(l) (0x0F00 | ((l) << 12))
#define TPM_RID(l) (0x0F04 | ((l) << 12))
struct tpm_tis_tcg_phy {
struct tpm_tis_data priv;
void __iomem *iobase;
};
static inline struct tpm_tis_tcg_phy *to_tpm_tis_tcg_phy(struct tpm_tis_data *data)
{
return container_of(data, struct tpm_tis_tcg_phy, priv);
}
#if defined(CONFIG_PNP) && defined(CONFIG_ACPI)
static int has_hid(struct acpi_device *dev, const char *hid)
{
struct acpi_hardware_id *id;
list_for_each_entry(id, &dev->pnp.ids, list)
if (!strcmp(hid, id->id))
return 1;
return 0;
}
static inline int is_itpm(struct acpi_device *dev)
{
return has_hid(dev, "INTC0102");
}
#else
static inline int is_itpm(struct acpi_device *dev)
{
return 0;
}
#endif
/* Before we attempt to access the TPM we must see that the valid bit is set.
* The specification says that this bit is 0 at reset and remains 0 until the
* 'TPM has gone through its self test and initialization and has established
* correct values in the other bits.' */
static int wait_startup(struct tpm_chip *chip, int l)
{
struct tpm_tis_data *priv = dev_get_drvdata(&chip->dev);
struct tpm_tis_tcg_phy *phy =