1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
284
285
286
287
288
289
290
291
292
293
294
295
296
297
298
299
300
301
302
303
304
305
306
307
308
309
310
311
312
313
314
315
316
317
318
319
320
321
322
323
324
325
326
327
328
329
330
331
332
333
334
335
336
337
338
339
340
341
342
343
344
345
346
347
348
349
350
351
352
353
354
355
356
357
358
359
360
361
362
363
364
365
|
/*
* External Interrupt Controller on Spider South Bridge
*
* (C) Copyright IBM Deutschland Entwicklung GmbH 2005
*
* Author: Arnd Bergmann <arndb@de.ibm.com>
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; either version 2, or (at your option)
* any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program; if not, write to the Free Software
* Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
*/
#include <linux/interrupt.h>
#include <linux/irq.h>
#include <linux/ioport.h>
#include <asm/pgtable.h>
#include <asm/prom.h>
#include <asm/io.h>
#include "interrupt.h"
/* register layout taken from Spider spec, table 7.4-4 */
enum {
TIR_DEN = 0x004, /* Detection Enable Register */
TIR_MSK = 0x084, /* Mask Level Register */
TIR_EDC = 0x0c0, /* Edge Detection Clear Register */
TIR_PNDA = 0x100, /* Pending Register A */
TIR_PNDB = 0x104, /* Pending Register B */
TIR_CS = 0x144, /* Current Status Register */
TIR_LCSA = 0x150, /* Level Current Status Register A */
TIR_LCSB = 0x154, /* Level Current Status Register B */
TIR_LCSC = 0x158, /* Level Current Status Register C */
TIR_LCSD = 0x15c, /* Level Current Status Register D */
TIR_CFGA = 0x200, /* Setting Register A0 */
TIR_CFGB = 0x204, /* Setting Register B0 */
/* 0x208 ... 0x3ff Setting Register An/Bn */
TIR_PPNDA = 0x400, /* Packet Pending Register A */
TIR_PPNDB = 0x404, /* Packet Pending Register B */
TIR_PIERA = 0x408, /* Packet Output Error Register A */
TIR_PIERB = 0x40c, /* Packet Output Error Register B */
TIR_PIEN = 0x444, /* Packet Output Enable Register */
TIR_PIPND = 0x454, /* Packet Output Pending Register */
TIRDID = 0x484, /* Spider Device ID Register */
REISTIM = 0x500, /* Reissue Command Timeout Time Setting */
REISTIMEN = 0x504, /* Reissue Command Timeout Setting */
REISWAITEN = 0x508, /* Reissue Wait Control*/
};
#define SPIDER_CHIP_COUNT 4
#define SPIDER_SRC_COUNT 64
#define SPIDER_IRQ_INVALID 63
struct spider_pic {
struct irq_host *host;
void __iomem *regs;
unsigned int node_id;
};
static struct spider_pic spider_pics[SPIDER_CHIP_COUNT];
static struct spider_pic *spider_virq_to_pic(unsigned int virq)
{
return irq_map[virq].host->host_data;
}
static void __iomem *spider_get_irq_config(struct spider_pic *pic,
unsigned int src)
{
return pic->regs + TIR_CFGA + 8 * src;
}
static void spider_unmask_irq(unsigned int virq)
{
struct spider_pic *pic = spider_virq_to_pic(virq);
void __iomem *cfg = spider_get_irq_config(pic, irq_map[virq].hwirq);
out_be32(cfg, in_be32(cfg) | 0x30000000u);
}
static void spider_mask_irq(unsigned int virq)
{
struct spider_pic *pic = spider_virq_to_pic(virq);
void __iomem *cfg = spider_get_irq_config(pic, irq_map[virq].hwirq);
out_be32(cfg, in_be32(cfg) & ~0x30000000u);
}
static void spider_ack_irq(unsigned int virq)
{
struct spider_pic *pic = spider_virq_to_pic(virq);
unsigned int src = irq_map[virq].hwirq;
/* Reset edge detection logic if necessary
*/
if (irq_to_desc(virq)->status & IRQ_LEVEL)
return;
/* Only interrupts 47 to 50 can be set to edge */
if (src < 47 || src > 50)
return;
/* Perform the clear of the edge logic */
out_be32(pic->regs + TIR_EDC, 0x100 | (src & 0xf));
}
static int spider_set_irq_type(unsigned int virq, unsigned int type)
{
unsigned int sense = type & IRQ_TYPE_SENSE_MASK;
struct spider_pic *pic = spider_virq_to_pic(virq);
unsigned int hw = irq_map[virq].hwirq;
void __iomem *cfg = spider_get_irq_config(pic, hw);
struct irq_desc *desc = irq_to_desc(virq);
u32 old_mask;
u32 ic;
/* Note that only level high is supported for most interrupts */
if (sense != IRQ_TYPE_NONE && sense != IRQ_TYPE_LEVEL_HIGH &&
(hw < 47 || hw > 50))
return -EINVAL;
/* Decode sense type */
switch(sense) {
case IRQ_TYPE_EDGE_RISING:
ic = 0x3;
break;
case IRQ_TYPE_EDGE_FALLING:
ic = 0x2;
break;
case IRQ_TYPE_LEVEL_LOW:
ic = 0x0;
break;
case IRQ_TYPE_LEVEL_HIGH:
case IRQ_TYPE_NONE:
ic = 0x1;
break;
default:
return -EINVAL;
}
/* Update irq_desc */
desc->status &= ~(IRQ_TYPE_SENSE_MASK | IRQ_LEVEL);
desc->status |= type & IRQ_TYPE_SENSE_MASK;
if (type & (IRQ_TYPE_LEVEL_HIGH | IRQ_TYPE_LEVEL_LOW))
desc->status |= IRQ_LEVEL;
/* Configure the source. One gross hack that was there before and
* that I've kept around is the priority to the BE which I set to
* be the same as the interrupt source number. I don't know wether
* that's supposed to make any kind of sense however, we'll have to
* decide that, but for now, I'm not changing the behaviour.
*/
old_mask = in_be32(cfg) & 0x30000000u;
out_be32(cfg, old_mask | (ic << 24) | (0x7 << 16) |
(pic->node_id << 4) | 0xe);
out_be32(cfg + 4, (0x2 << 16) | (hw & 0xff));
return 0;
}
static struct irq_chip spider_pic = {
.name = " SPIDER ",
.unmask = spider_unmask_irq,
.mask = spider_mask_irq,
.ack = spider_ack_irq,
.set_type = spider_set_irq_type,
};
static int spider_host_map(struct irq_host *h, unsigned int virq,
irq_hw_number_t hw)
{
set_irq_chip_and_handler(virq, &spider_pic, handle_level_irq);
/* Set default irq type */
set_irq_type(virq, IRQ_TYPE_NONE);
return 0;
}
static int spider_host_xlate(struct irq_host *h, struct device_node *ct,
u32 *intspec, unsigned int intsize,
irq_hw_number_t *out_hwirq, unsigned int *out_flags)
{
/* Spider interrupts have 2 cells, first is the interrupt source,
* second, well, I don't know for sure yet ... We mask the top bits
* because old device-trees encode a node number in there
*/
*out_hwirq = intspec[0] & 0x3f;
*out_flags = IRQ_TYPE_LEVEL_HIGH;
return 0;
}
static struct irq_host_ops spider_host_ops = {
.map = spider_host_map,
.xlate = spider_host_xlate,
};
static void spider_irq_cascade(unsigned int irq, struct irq_desc *desc)
{
struct spider_pic *pic = desc->handler_data;
unsigned int cs, virq;
cs = in_be32(pic->regs + TIR_CS) >> 24;
if (cs == SPIDER_IRQ_INVALID)
virq = NO_IRQ;
else
virq = irq_linear_revmap(pic->host, cs);
if (virq != NO_IRQ)
generic_handle_irq(virq);
desc->chip->eoi(irq);
}
/* For hooking up the cascace we have a problem. Our device-tree is
* crap and we don't know on which BE iic interrupt we are hooked on at
* least not the "standard" way. We can reconstitute it based on two
* informations though: which BE node we are connected to and wether
* we are connected to IOIF0 or IOIF1. Right now, we really only care
* about the IBM cell blade and we know that its firmware gives us an
* interrupt-map property which is pretty strange.
*/
static unsigned int __init spider_find_cascade_and_node(struct spider_pic *pic)
{
unsigned int virq;
const u32 *imap, *tmp;
int imaplen, intsize, unit;
struct device_node *iic;
/* First, we check wether we have a real "interrupts" in the device
* tree in case the device-tree is ever fixed
*/
struct of_irq oirq;
if (of_irq_map_one(pic->host->of_node, 0, &oirq) == 0) {
virq = irq_create_of_mapping(oirq.controller, oirq.specifier,
oirq.size);
return virq;
}
/* Now do the horrible hacks */
tmp = of_get_property(pic->host->of_node, "#interrupt-cells", NULL);
if (tmp == NULL)
return NO_IRQ;
intsize = *tmp;
imap = of_get_property(pic->host->of_node, "interrupt-map", &imaplen);
if (imap == NULL || imaplen < (intsize + 1))
return NO_IRQ;
iic = of_find_node_by_phandle(imap[intsize]);
if
|