1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
284
285
286
287
288
289
290
291
292
293
294
295
296
297
298
299
300
301
302
303
304
305
306
307
308
309
310
311
312
313
314
315
316
317
318
319
320
321
322
323
324
325
326
327
328
329
330
331
332
333
334
335
336
337
338
339
340
341
342
343
344
345
346
347
348
349
350
351
352
353
354
355
356
357
358
359
360
361
362
363
364
365
366
367
368
369
370
371
372
373
374
375
376
377
378
379
380
381
382
383
384
385
386
387
|
// SPDX-License-Identifier: GPL-2.0-or-later
/*
* thermal support for the cell processor
*
* This module adds some sysfs attributes to cpu and spu nodes.
* Base for measurements are the digital thermal sensors (DTS)
* located on the chip.
* The accuracy is 2 degrees, starting from 65 up to 125 degrees celsius
* The attributes can be found under
* /sys/devices/system/cpu/cpuX/thermal
* /sys/devices/system/spu/spuX/thermal
*
* The following attributes are added for each node:
* temperature:
* contains the current temperature measured by the DTS
* throttle_begin:
* throttling begins when temperature is greater or equal to
* throttle_begin. Setting this value to 125 prevents throttling.
* throttle_end:
* throttling is being ceased, if the temperature is lower than
* throttle_end. Due to a delay between applying throttling and
* a reduced temperature this value should be less than throttle_begin.
* A value equal to throttle_begin provides only a very little hysteresis.
* throttle_full_stop:
* If the temperatrue is greater or equal to throttle_full_stop,
* full throttling is applied to the cpu or spu. This value should be
* greater than throttle_begin and throttle_end. Setting this value to
* 65 prevents the unit from running code at all.
*
* (C) Copyright IBM Deutschland Entwicklung GmbH 2005
*
* Author: Christian Krafft <krafft@de.ibm.com>
*/
#include <linux/module.h>
#include <linux/device.h>
#include <linux/kernel.h>
#include <linux/cpu.h>
#include <linux/stringify.h>
#include <asm/spu.h>
#include <asm/io.h>
#include <asm/prom.h>
#include <asm/cell-regs.h>
#include "spu_priv1_mmio.h"
#define TEMP_MIN 65
#define TEMP_MAX 125
#define DEVICE_PREFIX_ATTR(_prefix,_name,_mode) \
struct device_attribute attr_ ## _prefix ## _ ## _name = { \
.attr = { .name = __stringify(_name), .mode = _mode }, \
.show = _prefix ## _show_ ## _name, \
.store = _prefix ## _store_ ## _name, \
};
static inline u8 reg_to_temp(u8 reg_value)
{
return ((reg_value & 0x3f) << 1) + TEMP_MIN;
}
static inline u8 temp_to_reg(u8 temp)
{
return ((temp - TEMP_MIN) >> 1) & 0x3f;
}
static struct cbe_pmd_regs __iomem *get_pmd_regs(struct device *dev)
{
struct spu *spu;
spu = container_of(dev, struct spu, dev);
return cbe_get_pmd_regs(spu_devnode(spu));
}
/* returns the value for a given spu in a given register */
static u8 spu_read_register_value(struct device *dev, union spe_reg __iomem *reg)
{
union spe_reg value;
struct spu *spu;
spu = container_of(dev, struct spu, dev);
value.val = in_be64(®->val);
return value.spe[spu->spe_id];
}
static ssize_t spu_show_temp(struct device *dev, struct device_attribute *attr,
char *buf)
{
u8 value;
struct cbe_pmd_regs __iomem *pmd_regs;
pmd_regs = get_pmd_regs(dev);
value = spu_read_register_value(dev, &pmd_regs->ts_ctsr1);
return sprintf(buf, "%d\n", reg_to_temp(value));
}
static ssize_t show_throttle(struct cbe_pmd_regs __iomem *pmd_regs, char *buf, int pos)
{
u64 value;
value = in_be64(&pmd_regs->tm_tpr.val);
/* access the corresponding byte */
value >>= pos;
value &= 0x3F;
return sprintf(buf, "%d\n", reg_to_temp(value));
}
static ssize_t store_throttle(struct cbe_pmd_regs __iomem *pmd_regs, const char *buf, size_t size, int pos)
{
u64 reg_value;
unsigned int temp;
u64 new_value;
int ret;
ret = sscanf(buf, "%u", &temp);
if (ret != 1 || temp < TEMP_MIN || temp > TEMP_MAX)
return -EINVAL;
new_value = temp_to_reg(temp);
reg_value = in_be64(&pmd_regs->tm_tpr.val);
/* zero out bits for new value */
reg_value &= ~(0xffull << pos);
/* set bits to new value */
reg_value |= new_value << pos;
out_be64(&pmd_regs->tm_tpr.val, reg_value);
return size;
}
static ssize_t spu_show_throttle_end(struct device *dev,
struct device_attribute *attr, char *buf)
{
return show_throttle(get_pmd_regs(dev), buf, 0);
}
static ssize_t spu_show_throttle_begin(struct device *dev,
struct device_attribute *attr, char *buf)
{
return show_throttle(get_pmd_regs(dev), buf, 8);
}
static ssize_t spu_show_throttle_full_stop(struct device *dev,
struct device_attribute *attr, char *buf)
{
return show_throttle(get_pmd_regs(dev), buf, 16);
}
static ssize_t spu_store_throttle_end(struct device *dev,
struct device_attribute *attr, const char *buf, size_t size)
{
return store_throttle(get_pmd_regs(dev), buf, size, 0);
}
static ssize_t spu_store_throttle_begin(struct device *dev,
struct device_attribute *attr, const char *buf, size_t size)
{
return store_throttle(get_pmd_regs(dev), buf, size, 8);
}
static ssize_t spu_store_throttle_full_stop(struct device *dev,
struct device_attribute *attr, const char *buf, size_t size)
{
return store_throttle(get_pmd_regs(dev), buf, size, 16);
}
static ssize_t ppe_show_temp(struct device *dev, char *buf, int pos)
{
struct cbe_pmd_regs __iomem *pmd_regs;
u64 value;
pmd_regs = cbe_get_cpu_pmd_regs(dev->id);
value = in_be64(&pmd_regs->ts_ctsr2);
value = (value >> pos) & 0x3f;
return sprintf(buf, "%d\n", reg_to_temp(value));
}
/* shows the temperature of the DTS on the PPE,
* located near the linear thermal sensor */
static ssize_t ppe_show_temp0(struct device *dev,
struct device_attribute *attr, char *buf)
{
return ppe_show_temp(dev, buf, 32);
}
/* shows the temperature of the second DTS on the PPE */
static ssize_t ppe_show_temp1(struct device *dev,
struct device_attribute *attr, char *buf)
{
return ppe_show_temp(dev, buf, 0);
}
static ssize_t ppe_show_throttle_end(struct device *dev,
struct device_attribute *attr, char *buf)
{
return show_throttle(cbe_get_cpu_pmd_regs(dev->id), buf, 32);
}
static ssize_t ppe_show_throttle_begin(struct device *dev,
struct device_attribute *attr, char *buf)
{
return show_throttle(cbe_get_cpu_pmd_regs(dev->id), buf, 40);
}
static ssize_t ppe_show_throttle_full_stop(struct device *dev,
struct device_attribute *attr, char *buf)
{
return show_throttle(cbe_get_cpu_pmd_regs(dev->id), buf, 48);
}
static ssize_t ppe_store_throttle_end(struct device *dev,
struct device_attribute *attr, const char *buf, size_t size)
{
return store_throttle(cbe_get_cpu_pmd_regs(dev->id), buf, size, 32);
}
static ssize_t ppe_store_throttle_begin(struct device *dev,
struct device_attribute *attr, const char *buf, size_t size)
{
return store_throttle(cbe_get_cpu_pmd_regs(dev->id), buf, size, 40);
}
static ssize_t ppe_store_throttle_full_stop(struct device *dev,
struct device_attribute *attr, const char *buf, size_t size)
{
return store_throttle(cbe_get_cpu_pmd_regs(dev->id), buf, size, 48);
}
static struct device_attribute attr_spu_temperature = {
.attr = {.name = "temperature", .mode = 0400 },
.show = spu_show_temp,
};
static DEVICE_PREFIX_ATTR(spu, throttle_end, 0600);
static DEVICE_PREFIX_ATTR(spu, throttle_begin, 0600);
static DEVICE_PREFIX_ATTR(spu, throttle_full_stop, 0600);
static struct attribute *spu_attributes[] = {
&attr_spu_temperature.attr,
&attr_spu_throttle_end.attr,
&attr_spu_throttle_begin.attr,
&attr_spu_throttle_full_stop.attr,
NULL,
};
static struct attribute_group spu_attribute_group = {
.name = "thermal",
.attrs = spu_attributes,
};
static struct device_attribute attr_ppe_temperature0
|