diff options
Diffstat (limited to 'drivers/gpu/drm/bridge/ti-sn65dsi86.c')
-rw-r--r-- | drivers/gpu/drm/bridge/ti-sn65dsi86.c | 215 |
1 files changed, 215 insertions, 0 deletions
diff --git a/drivers/gpu/drm/bridge/ti-sn65dsi86.c b/drivers/gpu/drm/bridge/ti-sn65dsi86.c index 6ad688b320ae..3b91fa0ebdf9 100644 --- a/drivers/gpu/drm/bridge/ti-sn65dsi86.c +++ b/drivers/gpu/drm/bridge/ti-sn65dsi86.c @@ -4,9 +4,11 @@ * datasheet: http://www.ti.com/lit/ds/symlink/sn65dsi86.pdf */ +#include <linux/bits.h> #include <linux/clk.h> #include <linux/debugfs.h> #include <linux/gpio/consumer.h> +#include <linux/gpio/driver.h> #include <linux/i2c.h> #include <linux/iopoll.h> #include <linux/module.h> @@ -54,6 +56,14 @@ #define BPP_18_RGB BIT(0) #define SN_HPD_DISABLE_REG 0x5C #define HPD_DISABLE BIT(0) +#define SN_GPIO_IO_REG 0x5E +#define SN_GPIO_INPUT_SHIFT 4 +#define SN_GPIO_OUTPUT_SHIFT 0 +#define SN_GPIO_CTRL_REG 0x5F +#define SN_GPIO_MUX_INPUT 0 +#define SN_GPIO_MUX_OUTPUT 1 +#define SN_GPIO_MUX_SPECIAL 2 +#define SN_GPIO_MUX_MASK 0x3 #define SN_AUX_WDATA_REG(x) (0x64 + (x)) #define SN_AUX_ADDR_19_16_REG 0x74 #define SN_AUX_ADDR_15_8_REG 0x75 @@ -88,6 +98,35 @@ #define SN_REGULATOR_SUPPLY_NUM 4 +#define SN_NUM_GPIOS 4 +#define SN_GPIO_PHYSICAL_OFFSET 1 + +/** + * struct ti_sn_bridge - Platform data for ti-sn65dsi86 driver. + * @dev: Pointer to our device. + * @regmap: Regmap for accessing i2c. + * @aux: Our aux channel. + * @bridge: Our bridge. + * @connector: Our connector. + * @debugfs: Used for managing our debugfs. + * @host_node: Remote DSI node. + * @dsi: Our MIPI DSI source. + * @refclk: Our reference clock. + * @panel: Our panel. + * @enable_gpio: The GPIO we toggle to enable the bridge. + * @supplies: Data for bulk enabling/disabling our regulators. + * @dp_lanes: Count of dp_lanes we're using. + * + * @gchip: If we expose our GPIOs, this is used. + * @gchip_output: A cache of whether we've set GPIOs to output. This + * serves double-duty of keeping track of the direction and + * also keeping track of whether we've incremented the + * pm_runtime reference count for this pin, which we do + * whenever a pin is configured as an output. This is a + * bitmap so we can do atomic ops on it without an extra + * lock so concurrent users of our 4 GPIOs don't stomp on + * each other's read-modify-write. + */ struct ti_sn_bridge { struct device *dev; struct regmap *regmap; @@ -102,6 +141,9 @@ struct ti_sn_bridge { struct gpio_desc *enable_gpio; struct regulator_bulk_data supplies[SN_REGULATOR_SUPPLY_NUM]; int dp_lanes; + + struct gpio_chip gchip; + DECLARE_BITMAP(gchip_output, SN_NUM_GPIOS); }; static const struct regmap_range ti_sn_bridge_volatile_ranges[] = { @@ -874,6 +916,173 @@ static int ti_sn_bridge_parse_dsi_host(struct ti_sn_bridge *pdata) return 0; } +static int tn_sn_bridge_of_xlate(struct gpio_chip *chip, + const struct of_phandle_args *gpiospec, + u32 *flags) +{ + if (WARN_ON(gpiospec->args_count < chip->of_gpio_n_cells)) + return -EINVAL; + + if (gpiospec->args[0] > chip->ngpio || gpiospec->args[0] < 1) + return -EINVAL; + + if (flags) + *flags = gpiospec->args[1]; + + return gpiospec->args[0] - SN_GPIO_PHYSICAL_OFFSET; +} + +static int ti_sn_bridge_gpio_get_direction(struct gpio_chip *chip, + unsigned int offset) +{ + struct ti_sn_bridge *pdata = gpiochip_get_data(chip); + + /* + * We already have to keep track of the direction because we use + * that to figure out whether we've powered the device. We can + * just return that rather than (maybe) powering up the device + * to ask its direction. + */ + return test_bit(offset, pdata->gchip_output) ? + GPIO_LINE_DIRECTION_OUT : GPIO_LINE_DIRECTION_IN; +} + +static int ti_sn_bridge_gpio_get(struct gpio_chip *chip, unsigned int offset) +{ + struct ti_sn_bridge *pdata = gpiochip_get_data(chip); + unsigned int val; + int ret; + + /* + * When the pin is an input we don't forcibly keep the bridge + * powered--we just power it on to read the pin. NOTE: part of + * the reason this works is that the bridge defaults (when + * powered back on) to all 4 GPIOs being configured as GPIO input. + * Also note that if something else is keeping the chip powered the + * pm_runtime functions are lightweight increments of a refcount. + */ + pm_runtime_get_sync(pdata->dev); + ret = regmap_read(pdata->regmap, SN_GPIO_IO_REG, &val); + pm_runtime_put(pdata->dev); + + if (ret) + return ret; + + return !!(val & BIT(SN_GPIO_INPUT_SHIFT + offset)); +} + +static void ti_sn_bridge_gpio_set(struct gpio_chip *chip, unsigned int offset, + int val) +{ + struct ti_sn_bridge *pdata = gpiochip_get_data(chip); + int ret; + + if (!test_bit(offset, pdata->gchip_output)) { + dev_err(pdata->dev, "Ignoring GPIO set while input\n"); + return; + } + + val &= 1; + ret = regmap_update_bits(pdata->regmap, SN_GPIO_IO_REG, + BIT(SN_GPIO_OUTPUT_SHIFT + offset), + val << (SN_GPIO_OUTPUT_SHIFT + offset)); +} + +static int ti_sn_bridge_gpio_direction_input(struct gpio_chip *chip, + unsigned int offset) +{ + struct ti_sn_bridge *pdata = gpiochip_get_data(chip); + int shift = offset * 2; + int ret; + + if (!test_and_clear_bit(offset, pdata->gchip_output)) + return 0; + + ret = regmap_update_bits(pdata->regmap, SN_GPIO_CTRL_REG, + SN_GPIO_MUX_MASK << shift, + SN_GPIO_MUX_INPUT << shift); + if (ret) { + set_bit(offset, pdata->gchip_output); + return ret; + } + + /* + * NOTE: if nobody else is powering the device this may fully power + * it off and when it comes back it will have lost all state, but + * that's OK because the default is input and we're now an input. + */ + pm_runtime_put(pdata->dev); + + return 0; +} + +static int ti_sn_bridge_gpio_direction_output(struct gpio_chip *chip, + unsigned int offset, int val) +{ + struct ti_sn_bridge *pdata = gpiochip_get_data(chip); + int shift = offset * 2; + int ret; + + if (test_and_set_bit(offset, pdata->gchip_output)) + return 0; + + pm_runtime_get_sync(pdata->dev); + + /* Set value first to avoid glitching */ + ti_sn_bridge_gpio_set(chip, offset, val); + + /* Set direction */ + ret = regmap_update_bits(pdata->regmap, SN_GPIO_CTRL_REG, + SN_GPIO_MUX_MASK << shift, + SN_GPIO_MUX_OUTPUT << shift); + if (ret) { + clear_bit(offset, pdata->gchip_output); + pm_runtime_put(pdata->dev); + } + + return ret; +} + +static void ti_sn_bridge_gpio_free(struct gpio_chip *chip, unsigned int offset) +{ + /* We won't keep pm_runtime if we're input, so switch there on free */ + ti_sn_bridge_gpio_direction_input(chip, offset); +} + +static const char * const ti_sn_bridge_gpio_names[SN_NUM_GPIOS] = { + "GPIO1", "GPIO2", "GPIO3", "GPIO4" +}; + +static int ti_sn_setup_gpio_controller(struct ti_sn_bridge *pdata) +{ + int ret; + + /* Only init if someone is going to use us as a GPIO controller */ + if (!of_property_read_bool(pdata->dev->of_node, "gpio-controller")) + return 0; + + pdata->gchip.label = dev_name(pdata->dev); + pdata->gchip.parent = pdata->dev; + pdata->gchip.owner = THIS_MODULE; + pdata->gchip.of_xlate = tn_sn_bridge_of_xlate; + pdata->gchip.of_gpio_n_cells = 2; + pdata->gchip.free = ti_sn_bridge_gpio_free; + pdata->gchip.get_direction = ti_sn_bridge_gpio_get_direction; + pdata->gchip.direction_input = ti_sn_bridge_gpio_direction_input; + pdata->gchip.direction_output = ti_sn_bridge_gpio_direction_output; + pdata->gchip.get = ti_sn_bridge_gpio_get; + pdata->gchip.set = ti_sn_bridge_gpio_set; + pdata->gchip.can_sleep = true; + pdata->gchip.names = ti_sn_bridge_gpio_names; + pdata->gchip.ngpio = SN_NUM_GPIOS; + pdata->gchip.base = -1; + ret = devm_gpiochip_add_data(pdata->dev, &pdata->gchip, pdata); + if (ret) + dev_err(pdata->dev, "can't add gpio chip\n"); + + return ret; +} + static int ti_sn_bridge_probe(struct i2c_client *client, const struct i2c_device_id *id) { @@ -937,6 +1146,12 @@ static int ti_sn_bridge_probe(struct i2c_client *client, pm_runtime_enable(pdata->dev); + ret = ti_sn_setup_gpio_controller(pdata); + if (ret) { + pm_runtime_disable(pdata->dev); + return ret; + } + i2c_set_clientdata(client, pdata); pdata->aux.name = "ti-sn65dsi86-aux"; |