diff options
Diffstat (limited to 'Documentation')
-rw-r--r-- | Documentation/devicetree/bindings/regulator/gpio-regulator.txt | 30 |
1 files changed, 22 insertions, 8 deletions
diff --git a/Documentation/devicetree/bindings/regulator/gpio-regulator.txt b/Documentation/devicetree/bindings/regulator/gpio-regulator.txt index 1f496159e2bb..dd25e73b5d79 100644 --- a/Documentation/devicetree/bindings/regulator/gpio-regulator.txt +++ b/Documentation/devicetree/bindings/regulator/gpio-regulator.txt @@ -4,16 +4,30 @@ Required properties: - compatible : Must be "regulator-gpio". - regulator-name : Defined in regulator.txt as optional, but required here. -- states : Selection of available voltages and GPIO configs. - if there are no states, then use a fixed regulator +- gpios : Array of one or more GPIO pins used to select the + regulator voltage/current listed in "states". +- states : Selection of available voltages/currents provided by + this regulator and matching GPIO configurations to + achieve them. If there are no states in the "states" + array, use a fixed regulator instead. Optional properties: -- enable-gpio : GPIO to use to enable/disable the regulator. -- gpios : GPIO group used to control voltage. -- gpios-states : gpios pin's initial states array. 0: LOW, 1: HIGH. - defualt is LOW if nothing is specified. +- enable-gpios : GPIO used to enable/disable the regulator. + Warning, the GPIO phandle flags are ignored and the + GPIO polarity is controlled solely by the presence + of "enable-active-high" DT property. This is due to + compatibility with old DTs. +- enable-active-high : Polarity of "enable-gpio" GPIO is active HIGH. + Default is active LOW. +- gpios-states : On operating systems, that don't support reading back + gpio values in output mode (most notably linux), this + array provides the state of GPIO pins set when + requesting them from the gpio controller. Systems, + that are capable of preserving state when requesting + the lines, are free to ignore this property. + 0: LOW, 1: HIGH. Default is LOW if nothing else + is specified. - startup-delay-us : Startup time in microseconds. -- enable-active-high : Polarity of GPIO is active high (default is low). - regulator-type : Specifies what is being regulated, must be either "voltage" or "current", defaults to voltage. @@ -30,7 +44,7 @@ Example: regulator-max-microvolt = <2600000>; regulator-boot-on; - enable-gpio = <&gpio0 23 0x4>; + enable-gpios = <&gpio0 23 0x4>; gpios = <&gpio0 24 0x4 &gpio0 25 0x4>; states = <1800000 0x3 |