diff options
Diffstat (limited to 'Documentation/devicetree/bindings')
8 files changed, 15 insertions, 10 deletions
diff --git a/Documentation/devicetree/bindings/clock/sunxi-ccu.txt b/Documentation/devicetree/bindings/clock/sunxi-ccu.txt index e9c5a1d9834a..f465647a4dd2 100644 --- a/Documentation/devicetree/bindings/clock/sunxi-ccu.txt +++ b/Documentation/devicetree/bindings/clock/sunxi-ccu.txt @@ -22,7 +22,8 @@ Required properties : - #clock-cells : must contain 1 - #reset-cells : must contain 1 -For the PRCM CCUs on H3/A64, one more clock is needed: +For the PRCM CCUs on H3/A64, two more clocks are needed: +- "pll-periph": the SoC's peripheral PLL from the main CCU - "iosc": the SoC's internal frequency oscillator Example for generic CCU: @@ -39,8 +40,8 @@ Example for PRCM CCU: r_ccu: clock@01f01400 { compatible = "allwinner,sun50i-a64-r-ccu"; reg = <0x01f01400 0x100>; - clocks = <&osc24M>, <&osc32k>, <&iosc>; - clock-names = "hosc", "losc", "iosc"; + clocks = <&osc24M>, <&osc32k>, <&iosc>, <&ccu CLK_PLL_PERIPH0>; + clock-names = "hosc", "losc", "iosc", "pll-periph"; #clock-cells = <1>; #reset-cells = <1>; }; diff --git a/Documentation/devicetree/bindings/gpio/gpio-mvebu.txt b/Documentation/devicetree/bindings/gpio/gpio-mvebu.txt index 42c3bb2d53e8..01e331a5f3e7 100644 --- a/Documentation/devicetree/bindings/gpio/gpio-mvebu.txt +++ b/Documentation/devicetree/bindings/gpio/gpio-mvebu.txt @@ -41,9 +41,9 @@ Required properties: Optional properties: In order to use the GPIO lines in PWM mode, some additional optional -properties are required. Only Armada 370 and XP support these properties. +properties are required. -- compatible: Must contain "marvell,armada-370-xp-gpio" +- compatible: Must contain "marvell,armada-370-gpio" - reg: an additional register set is needed, for the GPIO Blink Counter on/off registers. @@ -71,7 +71,7 @@ Example: }; gpio1: gpio@18140 { - compatible = "marvell,armada-370-xp-gpio"; + compatible = "marvell,armada-370-gpio"; reg = <0x18140 0x40>, <0x181c8 0x08>; reg-names = "gpio", "pwm"; ngpios = <17>; diff --git a/Documentation/devicetree/bindings/mfd/stm32-timers.txt b/Documentation/devicetree/bindings/mfd/stm32-timers.txt index bbd083f5600a..1db6e0057a63 100644 --- a/Documentation/devicetree/bindings/mfd/stm32-timers.txt +++ b/Documentation/devicetree/bindings/mfd/stm32-timers.txt @@ -31,7 +31,7 @@ Example: compatible = "st,stm32-timers"; reg = <0x40010000 0x400>; clocks = <&rcc 0 160>; - clock-names = "clk_int"; + clock-names = "int"; pwm { compatible = "st,stm32-pwm"; diff --git a/Documentation/devicetree/bindings/net/dsa/b53.txt b/Documentation/devicetree/bindings/net/dsa/b53.txt index d6c6e41648d4..8ec2ca21adeb 100644 --- a/Documentation/devicetree/bindings/net/dsa/b53.txt +++ b/Documentation/devicetree/bindings/net/dsa/b53.txt @@ -34,7 +34,7 @@ Required properties: "brcm,bcm6328-switch" "brcm,bcm6368-switch" and the mandatory "brcm,bcm63xx-switch" -See Documentation/devicetree/bindings/dsa/dsa.txt for a list of additional +See Documentation/devicetree/bindings/net/dsa/dsa.txt for a list of additional required and optional properties. Examples: diff --git a/Documentation/devicetree/bindings/net/dsa/marvell.txt b/Documentation/devicetree/bindings/net/dsa/marvell.txt index 7ef9dbb08957..1d4d0f49c9d0 100644 --- a/Documentation/devicetree/bindings/net/dsa/marvell.txt +++ b/Documentation/devicetree/bindings/net/dsa/marvell.txt @@ -26,6 +26,10 @@ Optional properties: - interrupt-controller : Indicates the switch is itself an interrupt controller. This is used for the PHY interrupts. #interrupt-cells = <2> : Controller uses two cells, number and flag +- eeprom-length : Set to the length of an EEPROM connected to the + switch. Must be set if the switch can not detect + the presence and/or size of a connected EEPROM, + otherwise optional. - mdio : Container of PHY and devices on the switches MDIO bus. - mdio? : Container of PHYs and devices on the external MDIO diff --git a/Documentation/devicetree/bindings/net/smsc911x.txt b/Documentation/devicetree/bindings/net/smsc911x.txt index 16c3a9501f5d..acfafc8e143c 100644 --- a/Documentation/devicetree/bindings/net/smsc911x.txt +++ b/Documentation/devicetree/bindings/net/smsc911x.txt @@ -27,6 +27,7 @@ Optional properties: of the device. On many systems this is wired high so the device goes out of reset at power-on, but if it is under program control, this optional GPIO can wake up in response to it. +- vdd33a-supply, vddvario-supply : 3.3V analog and IO logic power supplies Examples: diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt index 71a3c134af1b..f01d154090da 100644 --- a/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt +++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt @@ -247,7 +247,6 @@ bias-bus-hold - latch weakly bias-pull-up - pull up the pin bias-pull-down - pull down the pin bias-pull-pin-default - use pin-default pull state -bi-directional - pin supports simultaneous input/output operations drive-push-pull - drive actively high and low drive-open-drain - drive with open drain drive-open-source - drive with open source @@ -260,7 +259,6 @@ input-debounce - debounce mode with debound time X power-source - select between different power supplies low-power-enable - enable low power mode low-power-disable - disable low power mode -output-enable - enable output on pin regardless of output value output-low - set the pin to output mode with low level output-high - set the pin to output mode with high level slew-rate - set the slew rate diff --git a/Documentation/devicetree/bindings/usb/dwc2.txt b/Documentation/devicetree/bindings/usb/dwc2.txt index 00bea038639e..fcf199b64d3d 100644 --- a/Documentation/devicetree/bindings/usb/dwc2.txt +++ b/Documentation/devicetree/bindings/usb/dwc2.txt @@ -10,6 +10,7 @@ Required properties: - "rockchip,rk3288-usb", "rockchip,rk3066-usb", "snps,dwc2": for rk3288 Soc; - "lantiq,arx100-usb": The DWC2 USB controller instance in Lantiq ARX SoCs; - "lantiq,xrx200-usb": The DWC2 USB controller instance in Lantiq XRX SoCs; + - "amlogic,meson8-usb": The DWC2 USB controller instance in Amlogic Meson8 SoCs; - "amlogic,meson8b-usb": The DWC2 USB controller instance in Amlogic Meson8b SoCs; - "amlogic,meson-gxbb-usb": The DWC2 USB controller instance in Amlogic S905 SoCs; - "amcc,dwc-otg": The DWC2 USB controller instance in AMCC Canyonlands 460EX SoCs; |