diff options
-rw-r--r-- | drivers/scsi/scsi_lib.c | 329 |
1 files changed, 175 insertions, 154 deletions
diff --git a/drivers/scsi/scsi_lib.c b/drivers/scsi/scsi_lib.c index 02892408962b..16a7e6846cac 100644 --- a/drivers/scsi/scsi_lib.c +++ b/drivers/scsi/scsi_lib.c @@ -761,6 +761,172 @@ static blk_status_t scsi_result_to_blk_status(struct scsi_cmnd *cmd, int result) } } +/* Helper for scsi_io_completion() when special action required. */ +static void scsi_io_completion_action(struct scsi_cmnd *cmd, int result) +{ + struct request_queue *q = cmd->device->request_queue; + struct request *req = cmd->request; + int level = 0; + enum {ACTION_FAIL, ACTION_REPREP, ACTION_RETRY, + ACTION_DELAYED_RETRY} action; + unsigned long wait_for = (cmd->allowed + 1) * req->timeout; + struct scsi_sense_hdr sshdr; + bool sense_valid; + bool sense_current = true; /* false implies "deferred sense" */ + blk_status_t blk_stat; + + sense_valid = scsi_command_normalize_sense(cmd, &sshdr); + if (sense_valid) + sense_current = !scsi_sense_is_deferred(&sshdr); + + blk_stat = scsi_result_to_blk_status(cmd, result); + + if (host_byte(result) == DID_RESET) { + /* Third party bus reset or reset for error recovery + * reasons. Just retry the command and see what + * happens. + */ + action = ACTION_RETRY; + } else if (sense_valid && sense_current) { + switch (sshdr.sense_key) { + case UNIT_ATTENTION: + if (cmd->device->removable) { + /* Detected disc change. Set a bit + * and quietly refuse further access. + */ + cmd->device->changed = 1; + action = ACTION_FAIL; + } else { + /* Must have been a power glitch, or a + * bus reset. Could not have been a + * media change, so we just retry the + * command and see what happens. + */ + action = ACTION_RETRY; + } + break; + case ILLEGAL_REQUEST: + /* If we had an ILLEGAL REQUEST returned, then + * we may have performed an unsupported + * command. The only thing this should be + * would be a ten byte read where only a six + * byte read was supported. Also, on a system + * where READ CAPACITY failed, we may have + * read past the end of the disk. + */ + if ((cmd->device->use_10_for_rw && + sshdr.asc == 0x20 && sshdr.ascq == 0x00) && + (cmd->cmnd[0] == READ_10 || + cmd->cmnd[0] == WRITE_10)) { + /* This will issue a new 6-byte command. */ + cmd->device->use_10_for_rw = 0; + action = ACTION_REPREP; + } else if (sshdr.asc == 0x10) /* DIX */ { + action = ACTION_FAIL; + blk_stat = BLK_STS_PROTECTION; + /* INVALID COMMAND OPCODE or INVALID FIELD IN CDB */ + } else if (sshdr.asc == 0x20 || sshdr.asc == 0x24) { + action = ACTION_FAIL; + blk_stat = BLK_STS_TARGET; + } else + action = ACTION_FAIL; + break; + case ABORTED_COMMAND: + action = ACTION_FAIL; + if (sshdr.asc == 0x10) /* DIF */ + blk_stat = BLK_STS_PROTECTION; + break; + case NOT_READY: + /* If the device is in the process of becoming + * ready, or has a temporary blockage, retry. + */ + if (sshdr.asc == 0x04) { + switch (sshdr.ascq) { + case 0x01: /* becoming ready */ + case 0x04: /* format in progress */ + case 0x05: /* rebuild in progress */ + case 0x06: /* recalculation in progress */ + case 0x07: /* operation in progress */ + case 0x08: /* Long write in progress */ + case 0x09: /* self test in progress */ + case 0x14: /* space allocation in progress */ + case 0x1a: /* start stop unit in progress */ + case 0x1b: /* sanitize in progress */ + case 0x1d: /* configuration in progress */ + case 0x24: /* depopulation in progress */ + action = ACTION_DELAYED_RETRY; + break; + default: + action = ACTION_FAIL; + break; + } + } else + action = ACTION_FAIL; + break; + case VOLUME_OVERFLOW: + /* See SSC3rXX or current. */ + action = ACTION_FAIL; + break; + default: + action = ACTION_FAIL; + break; + } + } else + action = ACTION_FAIL; + + if (action != ACTION_FAIL && + time_before(cmd->jiffies_at_alloc + wait_for, jiffies)) + action = ACTION_FAIL; + + switch (action) { + case ACTION_FAIL: + /* Give up and fail the remainder of the request */ + if (!(req->rq_flags & RQF_QUIET)) { + static DEFINE_RATELIMIT_STATE(_rs, + DEFAULT_RATELIMIT_INTERVAL, + DEFAULT_RATELIMIT_BURST); + + if (unlikely(scsi_logging_level)) + level = + SCSI_LOG_LEVEL(SCSI_LOG_MLCOMPLETE_SHIFT, + SCSI_LOG_MLCOMPLETE_BITS); + + /* + * if logging is enabled the failure will be printed + * in scsi_log_completion(), so avoid duplicate messages + */ + if (!level && __ratelimit(&_rs)) { + scsi_print_result(cmd, NULL, FAILED); + if (driver_byte(result) & DRIVER_SENSE) + scsi_print_sense(cmd); + scsi_print_command(cmd); + } + } + if (!scsi_end_request(req, blk_stat, blk_rq_err_bytes(req), 0)) + return; + /*FALLTHRU*/ + case ACTION_REPREP: + /* Unprep the request and put it back at the head of the queue. + * A new command will be prepared and issued. + */ + if (q->mq_ops) { + scsi_mq_requeue_cmd(cmd); + } else { + scsi_release_buffers(cmd); + scsi_requeue_command(q, cmd); + } + break; + case ACTION_RETRY: + /* Retry the same command immediately */ + __scsi_queue_insert(cmd, SCSI_MLQUEUE_EH_RETRY, false); + break; + case ACTION_DELAYED_RETRY: + /* Retry the same command after a delay */ + __scsi_queue_insert(cmd, SCSI_MLQUEUE_DEVICE_BUSY, false); + break; + } +} + /* * Helper for scsi_io_completion() when cmd->result is non-zero. Returns a * new result that may suppress further error checking. Also modifies @@ -869,20 +1035,9 @@ void scsi_io_completion(struct scsi_cmnd *cmd, unsigned int good_bytes) struct request_queue *q = cmd->device->request_queue; struct request *req = cmd->request; blk_status_t blk_stat = BLK_STS_OK; - struct scsi_sense_hdr sshdr; - bool sense_valid = false; - bool sense_current = true; /* false implies "deferred sense" */ - int level = 0; - enum {ACTION_FAIL, ACTION_REPREP, ACTION_RETRY, - ACTION_DELAYED_RETRY} action; - unsigned long wait_for = (cmd->allowed + 1) * req->timeout; - if (result) { /* does not necessarily mean there is an error */ - sense_valid = scsi_command_normalize_sense(cmd, &sshdr); - if (sense_valid) - sense_current = !scsi_sense_is_deferred(&sshdr); + if (result) /* does not necessarily mean there is an error */ result = scsi_io_completion_nz_result(cmd, result, &blk_stat); - } if (blk_rq_is_passthrough(req)) { /* @@ -936,138 +1091,12 @@ void scsi_io_completion(struct scsi_cmnd *cmd, unsigned int good_bytes) * If there had been no error, but we have leftover bytes in the * requeues just queue the command up again. */ - if (result == 0) - goto requeue; - - blk_stat = scsi_result_to_blk_status(cmd, result); - - if (host_byte(result) == DID_RESET) { - /* Third party bus reset or reset for error recovery - * reasons. Just retry the command and see what - * happens. - */ - action = ACTION_RETRY; - } else if (sense_valid && sense_current) { - switch (sshdr.sense_key) { - case UNIT_ATTENTION: - if (cmd->device->removable) { - /* Detected disc change. Set a bit - * and quietly refuse further access. - */ - cmd->device->changed = 1; - action = ACTION_FAIL; - } else { - /* Must have been a power glitch, or a - * bus reset. Could not have been a - * media change, so we just retry the - * command and see what happens. - */ - action = ACTION_RETRY; - } - break; - case ILLEGAL_REQUEST: - /* If we had an ILLEGAL REQUEST returned, then - * we may have performed an unsupported - * command. The only thing this should be - * would be a ten byte read where only a six - * byte read was supported. Also, on a system - * where READ CAPACITY failed, we may have - * read past the end of the disk. - */ - if ((cmd->device->use_10_for_rw && - sshdr.asc == 0x20 && sshdr.ascq == 0x00) && - (cmd->cmnd[0] == READ_10 || - cmd->cmnd[0] == WRITE_10)) { - /* This will issue a new 6-byte command. */ - cmd->device->use_10_for_rw = 0; - action = ACTION_REPREP; - } else if (sshdr.asc == 0x10) /* DIX */ { - action = ACTION_FAIL; - blk_stat = BLK_STS_PROTECTION; - /* INVALID COMMAND OPCODE or INVALID FIELD IN CDB */ - } else if (sshdr.asc == 0x20 || sshdr.asc == 0x24) { - action = ACTION_FAIL; - blk_stat = BLK_STS_TARGET; - } else - action = ACTION_FAIL; - break; - case ABORTED_COMMAND: - action = ACTION_FAIL; - if (sshdr.asc == 0x10) /* DIF */ - blk_stat = BLK_STS_PROTECTION; - break; - case NOT_READY: - /* If the device is in the process of becoming - * ready, or has a temporary blockage, retry. - */ - if (sshdr.asc == 0x04) { - switch (sshdr.ascq) { - case 0x01: /* becoming ready */ - case 0x04: /* format in progress */ - case 0x05: /* rebuild in progress */ - case 0x06: /* recalculation in progress */ - case 0x07: /* operation in progress */ - case 0x08: /* Long write in progress */ - case 0x09: /* self test in progress */ - case 0x14: /* space allocation in progress */ - case 0x1a: /* start stop unit in progress */ - case 0x1b: /* sanitize in progress */ - case 0x1d: /* configuration in progress */ - case 0x24: /* depopulation in progress */ - action = ACTION_DELAYED_RETRY; - break; - default: - action = ACTION_FAIL; - break; - } - } else - action = ACTION_FAIL; - break; - case VOLUME_OVERFLOW: - /* See SSC3rXX or current. */ - action = ACTION_FAIL; - break; - default: - action = ACTION_FAIL; - break; - } - } else - action = ACTION_FAIL; - - if (action != ACTION_FAIL && - time_before(cmd->jiffies_at_alloc + wait_for, jiffies)) - action = ACTION_FAIL; - - switch (action) { - case ACTION_FAIL: - /* Give up and fail the remainder of the request */ - if (!(req->rq_flags & RQF_QUIET)) { - static DEFINE_RATELIMIT_STATE(_rs, - DEFAULT_RATELIMIT_INTERVAL, - DEFAULT_RATELIMIT_BURST); - - if (unlikely(scsi_logging_level)) - level = SCSI_LOG_LEVEL(SCSI_LOG_MLCOMPLETE_SHIFT, - SCSI_LOG_MLCOMPLETE_BITS); - - /* - * if logging is enabled the failure will be printed - * in scsi_log_completion(), so avoid duplicate messages - */ - if (!level && __ratelimit(&_rs)) { - scsi_print_result(cmd, NULL, FAILED); - if (driver_byte(result) & DRIVER_SENSE) - scsi_print_sense(cmd); - scsi_print_command(cmd); - } - } - if (!scsi_end_request(req, blk_stat, blk_rq_err_bytes(req), 0)) - return; - /*FALLTHRU*/ - case ACTION_REPREP: - requeue: - /* Unprep the request and put it back at the head of the queue. - * A new command will be prepared and issued. + if (result == 0) { + /* + * Unprep the request and put it back at the head of the + * queue. A new command will be prepared and issued. + * This block is the same as case ACTION_REPREP in + * scsi_io_completion_action() above. */ if (q->mq_ops) { scsi_mq_requeue_cmd(cmd); @@ -1075,16 +1104,8 @@ void scsi_io_completion(struct scsi_cmnd *cmd, unsigned int good_bytes) scsi_release_buffers(cmd); scsi_requeue_command(q, cmd); } - break; - case ACTION_RETRY: - /* Retry the same command immediately */ - __scsi_queue_insert(cmd, SCSI_MLQUEUE_EH_RETRY, false); - break; - case ACTION_DELAYED_RETRY: - /* Retry the same command after a delay */ - __scsi_queue_insert(cmd, SCSI_MLQUEUE_DEVICE_BUSY, false); - break; - } + } else + scsi_io_completion_action(cmd, result); } static int scsi_init_sgtable(struct request *req, struct scsi_data_buffer *sdb) |