summaryrefslogtreecommitdiffstats
diff options
context:
space:
mode:
-rw-r--r--Documentation/devicetree/bindings/pinctrl/rockchip,pinctrl.txt46
-rw-r--r--drivers/pinctrl/pinctrl-rockchip.c119
2 files changed, 157 insertions, 8 deletions
diff --git a/Documentation/devicetree/bindings/pinctrl/rockchip,pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/rockchip,pinctrl.txt
index b0fb1018d7ad..f378d342aae4 100644
--- a/Documentation/devicetree/bindings/pinctrl/rockchip,pinctrl.txt
+++ b/Documentation/devicetree/bindings/pinctrl/rockchip,pinctrl.txt
@@ -21,10 +21,13 @@ defined as gpio sub-nodes of the pinmux controller.
Required properties for iomux controller:
- compatible: one of "rockchip,rk2928-pinctrl", "rockchip,rk3066a-pinctrl"
"rockchip,rk3066b-pinctrl", "rockchip,rk3188-pinctrl"
+ - reg: first element is the general register space of the iomux controller
+ second element is the separate pull register space of the rk3188
Required properties for gpio sub nodes:
- - compatible: "rockchip,gpio-bank"
+ - compatible: "rockchip,gpio-bank", "rockchip,rk3188-gpio-bank0"
- reg: register of the gpio bank (different than the iomux registerset)
+ second element: separate pull register for rk3188 bank0
- interrupts: base interrupt of the gpio bank in the interrupt controller
- clocks: clock that drives this bank
- gpio-controller: identifies the node as a gpio controller and pin bank.
@@ -95,3 +98,44 @@ uart2: serial@20064000 {
pinctrl-names = "default";
pinctrl-0 = <&uart2_xfer>;
};
+
+Example for rk3188:
+
+ pinctrl@20008000 {
+ compatible = "rockchip,rk3188-pinctrl";
+ reg = <0x20008000 0xa0>,
+ <0x20008164 0x1a0>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+
+ gpio0: gpio0@0x2000a000 {
+ compatible = "rockchip,rk3188-gpio-bank0";
+ reg = <0x2000a000 0x100>,
+ <0x20004064 0x8>;
+ interrupts = <GIC_SPI 54 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&clk_gates8 9>;
+
+ gpio-controller;
+ #gpio-cells = <2>;
+
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ };
+
+ gpio1: gpio1@0x2003c000 {
+ compatible = "rockchip,gpio-bank";
+ reg = <0x2003c000 0x100>;
+ interrupts = <GIC_SPI 55 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&clk_gates8 10>;
+
+ gpio-controller;
+ #gpio-cells = <2>;
+
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ };
+
+ ...
+
+ };
diff --git a/drivers/pinctrl/pinctrl-rockchip.c b/drivers/pinctrl/pinctrl-rockchip.c
index 91027dd19f89..f5e53a723152 100644
--- a/drivers/pinctrl/pinctrl-rockchip.c
+++ b/drivers/pinctrl/pinctrl-rockchip.c
@@ -64,10 +64,12 @@ enum rockchip_pinctrl_type {
enum rockchip_pin_bank_type {
COMMON_BANK,
+ RK3188_BANK0,
};
/**
* @reg_base: register base of the gpio bank
+ * @reg_pull: optional separate register for additional pull settings
* @clk: clock of the gpio bank
* @irq: interrupt of the gpio bank
* @pin_base: first pin number
@@ -84,6 +86,7 @@ enum rockchip_pin_bank_type {
*/
struct rockchip_pin_bank {
void __iomem *reg_base;
+ void __iomem *reg_pull;
struct clk *clk;
int irq;
u32 pin_base;
@@ -157,6 +160,7 @@ struct rockchip_pmx_func {
struct rockchip_pinctrl {
void __iomem *reg_base;
+ void __iomem *reg_pull;
struct device *dev;
struct rockchip_pin_ctrl *ctrl;
struct pinctrl_desc pctl;
@@ -379,25 +383,71 @@ static void rk2928_calc_pull_reg_and_bit(struct rockchip_pin_bank *bank,
*bit = pin_num % RK2928_PULL_PINS_PER_REG;
};
+#define RK3188_PULL_BITS_PER_PIN 2
+#define RK3188_PULL_PINS_PER_REG 8
+#define RK3188_PULL_BANK_STRIDE 16
+
+static void rk3188_calc_pull_reg_and_bit(struct rockchip_pin_bank *bank,
+ int pin_num, void __iomem **reg, u8 *bit)
+{
+ struct rockchip_pinctrl *info = bank->drvdata;
+
+ /* The first 12 pins of the first bank are located elsewhere */
+ if (bank->bank_type == RK3188_BANK0 && pin_num < 12) {
+ *reg = bank->reg_pull +
+ ((pin_num / RK3188_PULL_PINS_PER_REG) * 4);
+ *bit = pin_num % RK3188_PULL_PINS_PER_REG;
+ *bit *= RK3188_PULL_BITS_PER_PIN;
+ } else {
+ *reg = info->reg_pull - 4;
+ *reg += bank->bank_num * RK3188_PULL_BANK_STRIDE;
+ *reg += ((pin_num / RK3188_PULL_PINS_PER_REG) * 4);
+
+ /*
+ * The bits in these registers have an inverse ordering
+ * with the lowest pin being in bits 15:14 and the highest
+ * pin in bits 1:0
+ */
+ *bit = 7 - (pin_num % RK3188_PULL_PINS_PER_REG);
+ *bit *= RK3188_PULL_BITS_PER_PIN;
+ }
+}
+
static int rockchip_get_pull(struct rockchip_pin_bank *bank, int pin_num)
{
struct rockchip_pinctrl *info = bank->drvdata;
struct rockchip_pin_ctrl *ctrl = info->ctrl;
void __iomem *reg;
u8 bit;
+ u32 data;
/* rk3066b does support any pulls */
if (ctrl->type == RK3066B)
return PIN_CONFIG_BIAS_DISABLE;
+ ctrl->pull_calc_reg(bank, pin_num, &reg, &bit);
+
switch (ctrl->type) {
case RK2928:
- ctrl->pull_calc_reg(bank, pin_num, &reg, &bit);
return !(readl_relaxed(reg) & BIT(bit))
? PIN_CONFIG_BIAS_PULL_PIN_DEFAULT
: PIN_CONFIG_BIAS_DISABLE;
case RK3188:
- dev_err(info->dev, "pull support for rk31xx not implemented\n");
+ data = readl_relaxed(reg) >> bit;
+ data &= (1 << RK3188_PULL_BITS_PER_PIN) - 1;
+
+ switch (data) {
+ case 0:
+ return PIN_CONFIG_BIAS_DISABLE;
+ case 1:
+ return PIN_CONFIG_BIAS_PULL_UP;
+ case 2:
+ return PIN_CONFIG_BIAS_PULL_DOWN;
+ case 3:
+ return PIN_CONFIG_BIAS_BUS_HOLD;
+ }
+
+ dev_err(info->dev, "unknown pull setting\n");
return -EIO;
default:
dev_err(info->dev, "unsupported pinctrl type\n");
@@ -422,10 +472,10 @@ static int rockchip_set_pull(struct rockchip_pin_bank *bank,
if (ctrl->type == RK3066B)
return pull ? -EINVAL : 0;
+ ctrl->pull_calc_reg(bank, pin_num, &reg, &bit);
+
switch (ctrl->type) {
case RK2928:
- ctrl->pull_calc_reg(bank, pin_num, &reg, &bit);
-
spin_lock_irqsave(&bank->slock, flags);
data = BIT(bit + 16);
@@ -436,8 +486,33 @@ static int rockchip_set_pull(struct rockchip_pin_bank *bank,
spin_unlock_irqrestore(&bank->slock, flags);
break;
case RK3188:
- dev_err(info->dev, "pull support for rk31xx not implemented\n");
- return -EIO;
+ spin_lock_irqsave(&bank->slock, flags);
+
+ /* enable the write to the equivalent lower bits */
+ data = ((1 << RK3188_PULL_BITS_PER_PIN) - 1) << (bit + 16);
+
+ switch (pull) {
+ case PIN_CONFIG_BIAS_DISABLE:
+ break;
+ case PIN_CONFIG_BIAS_PULL_UP:
+ data |= (1 << bit);
+ break;
+ case PIN_CONFIG_BIAS_PULL_DOWN:
+ data |= (2 << bit);
+ break;
+ case PIN_CONFIG_BIAS_BUS_HOLD:
+ data |= (3 << bit);
+ break;
+ default:
+ dev_err(info->dev, "unsupported pull setting %d\n",
+ pull);
+ return -EINVAL;
+ }
+
+ writel(data, reg);
+
+ spin_unlock_irqrestore(&bank->slock, flags);
+ break;
default:
dev_err(info->dev, "unsupported pinctrl type\n");
return -EINVAL;
@@ -608,6 +683,7 @@ static int rockchip_pinconf_set(struct pinctrl_dev *pctldev, unsigned int pin,
case PIN_CONFIG_BIAS_PULL_UP:
case PIN_CONFIG_BIAS_PULL_DOWN:
case PIN_CONFIG_BIAS_PULL_PIN_DEFAULT:
+ case PIN_CONFIG_BIAS_BUS_HOLD:
if (!rockchip_pinconf_pull_valid(info->ctrl, param))
return -ENOTSUPP;
@@ -646,6 +722,7 @@ static int rockchip_pinconf_get(struct pinctrl_dev *pctldev, unsigned int pin,
case PIN_CONFIG_BIAS_PULL_UP:
case PIN_CONFIG_BIAS_PULL_DOWN:
case PIN_CONFIG_BIAS_PULL_PIN_DEFAULT:
+ case PIN_CONFIG_BIAS_BUS_HOLD:
if (!rockchip_pinconf_pull_valid(info->ctrl, param))
return -ENOTSUPP;
@@ -669,6 +746,7 @@ static const struct pinconf_ops rockchip_pinconf_ops = {
static const struct of_device_id rockchip_bank_match[] = {
{ .compatible = "rockchip,gpio-bank" },
+ { .compatible = "rockchip,rk3188-gpio-bank0" },
{},
};
@@ -1220,7 +1298,25 @@ static int rockchip_get_bank_data(struct rockchip_pin_bank *bank,
if (IS_ERR(bank->reg_base))
return PTR_ERR(bank->reg_base);
- bank->bank_type = COMMON_BANK;
+ /*
+ * special case, where parts of the pull setting-registers are
+ * part of the PMU register space
+ */
+ if (of_device_is_compatible(bank->of_node,
+ "rockchip,rk3188-gpio-bank0")) {
+ bank->bank_type = RK3188_BANK0;
+
+ if (of_address_to_resource(bank->of_node, 1, &res)) {
+ dev_err(dev, "cannot find IO resource for bank\n");
+ return -ENOENT;
+ }
+
+ bank->reg_pull = devm_ioremap_resource(dev, &res);
+ if (IS_ERR(bank->reg_pull))
+ return PTR_ERR(bank->reg_pull);
+ } else {
+ bank->bank_type = COMMON_BANK;
+ }
bank->irq = irq_of_parse_and_map(bank->of_node, 0);
@@ -1306,6 +1402,14 @@ static int rockchip_pinctrl_probe(struct platform_device *pdev)
if (IS_ERR(info->reg_base))
return PTR_ERR(info->reg_base);
+ /* The RK3188 has its pull registers in a separate place */
+ if (ctrl->type == RK3188) {
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 1);
+ info->reg_pull = devm_ioremap_resource(&pdev->dev, res);
+ if (IS_ERR(info->reg_base))
+ return PTR_ERR(info->reg_base);
+ }
+
ret = rockchip_gpiolib_register(pdev, info);
if (ret)
return ret;
@@ -1383,6 +1487,7 @@ static struct rockchip_pin_ctrl rk3188_pin_ctrl = {
.label = "RK3188-GPIO",
.type = RK3188,
.mux_offset = 0x68,
+ .pull_calc_reg = rk3188_calc_pull_reg_and_bit,
};
static const struct of_device_id rockchip_pinctrl_dt_match[] = {