Merge tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

Pull ARM SoC driver updates from Olof Johansson:
 "Various driver updates for platforms:

   - A larger set of work on Tegra 2/3 around memory controller and
     regulator features, some fuse cleanups, etc..

   - MMP platform drivers, in particular for USB PHY, and other smaller
     additions.

   - Samsung Exynos 5422 driver for DMC (dynamic memory configuration),
     and ASV (adaptive voltage), allowing the platform to run at more
     optimal operating points.

   - Misc refactorings and support for RZ/G2N and R8A774B1 from Renesas

   - Clock/reset control driver for TI/OMAP

   - Meson-A1 reset controller support

   - Qualcomm sdm845 and sda845 SoC IDs for socinfo"

* tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (150 commits)
  firmware: arm_scmi: Fix doorbell ring logic for !CONFIG_64BIT
  soc: fsl: add RCPM driver
  dt-bindings: fsl: rcpm: Add 'little-endian' and update Chassis definition
  memory: tegra: Consolidate registers definition into common header
  memory: tegra: Ensure timing control debug features are disabled
  memory: tegra: Introduce Tegra30 EMC driver
  memory: tegra: Do not handle error from wait_for_completion_timeout()
  memory: tegra: Increase handshake timeout on Tegra20
  memory: tegra: Print a brief info message about EMC timings
  memory: tegra: Pre-configure debug register on Tegra20
  memory: tegra: Include io.h instead of iopoll.h
  memory: tegra: Adapt for Tegra20 clock driver changes
  memory: tegra: Don't set EMC rate to maximum on probe for Tegra20
  memory: tegra: Add gr2d and gr3d to DRM IOMMU group
  memory: tegra: Set DMA mask based on supported address bits
  soc: at91: Add Atmel SFR SN (Serial Number) support
  memory: atmel-ebi: switch to SPDX license identifiers
  memory: atmel-ebi: move NUM_CS definition inside EBI driver
  soc: mediatek: Refactor bus protection control
  soc: mediatek: Refactor sram control
  ...

2 files changed, 11 insertions, 4 deletions

diff --git a/Documentation/devicetree/bindings/soc/fsl/rcpm.txt b/Documentation/devicetree/bindings/soc/fsl/rcpm.txt
index e284e4e1ccd5..5a33619d881d 100644
--- a/Documentation/devicetree/bindings/soc/fsl/rcpm.txt
+++ b/Documentation/devicetree/bindings/soc/fsl/rcpm.txt
@@ -5,7 +5,7 @@ and power management.
 
 Required properites:
   - reg : Offset and length of the register set of the RCPM block.
-  - fsl,#rcpm-wakeup-cells : The number of IPPDEXPCR register cells in the
+  - #fsl,rcpm-wakeup-cells : The number of IPPDEXPCR register cells in the
 	fsl,rcpm-wakeup property.
   - compatible : Must contain a chip-specific RCPM block compatible string
 	and (if applicable) may contain a chassis-version RCPM compatible
@@ -20,6 +20,7 @@ Required properites:
 	* "fsl,qoriq-rcpm-1.0": for chassis 1.0 rcpm
 	* "fsl,qoriq-rcpm-2.0": for chassis 2.0 rcpm
 	* "fsl,qoriq-rcpm-2.1": for chassis 2.1 rcpm
+	* "fsl,qoriq-rcpm-2.1+": for chassis 2.1+ rcpm
 
 All references to "1.0" and "2.0" refer to the QorIQ chassis version to
 which the chip complies.
@@ -27,14 +28,19 @@ Chassis Version		Example Chips
 ---------------		-------------------------------
 1.0				p4080, p5020, p5040, p2041, p3041
 2.0				t4240, b4860, b4420
-2.1				t1040, ls1021
+2.1				t1040,
+2.1+				ls1021a, ls1012a, ls1043a, ls1046a
+
+Optional properties:
+ - little-endian : RCPM register block is Little Endian. Without it RCPM
+   will be Big Endian (default case).
 
 Example:
 The RCPM node for T4240:
 	rcpm: global-utilities@e2000 {
 		compatible = "fsl,t4240-rcpm", "fsl,qoriq-rcpm-2.0";
 		reg = <0xe2000 0x1000>;
-		fsl,#rcpm-wakeup-cells = <2>;
+		#fsl,rcpm-wakeup-cells = <2>;
 	};
 
 * Freescale RCPM Wakeup Source Device Tree Bindings
@@ -44,7 +50,7 @@ can be used as a wakeup source.
 
   - fsl,rcpm-wakeup: Consists of a phandle to the rcpm node and the IPPDEXPCR
 	register cells. The number of IPPDEXPCR register cells is defined in
-	"fsl,#rcpm-wakeup-cells" in the rcpm node. The first register cell is
+	"#fsl,rcpm-wakeup-cells" in the rcpm node. The first register cell is
 	the bit mask that should be set in IPPDEXPCR0, and the second register
 	cell is for IPPDEXPCR1, and so on.
 
diff --git a/Documentation/devicetree/bindings/soc/qcom/qcom,smd-rpm.txt b/Documentation/devicetree/bindings/soc/qcom/qcom,smd-rpm.txt
index f3fa313963d5..616fddcd09fd 100644
--- a/Documentation/devicetree/bindings/soc/qcom/qcom,smd-rpm.txt
+++ b/Documentation/devicetree/bindings/soc/qcom/qcom,smd-rpm.txt
@@ -22,6 +22,7 @@ resources.
 		    "qcom,rpm-apq8084"
 		    "qcom,rpm-msm8916"
 		    "qcom,rpm-msm8974"
+		    "qcom,rpm-msm8976"
 		    "qcom,rpm-msm8998"
 		    "qcom,rpm-sdm660"
 		    "qcom,rpm-qcs404"