diff options
Diffstat (limited to 'INSTALL')
-rw-r--r-- | INSTALL | 28 |
1 files changed, 26 insertions, 2 deletions
@@ -3,7 +3,7 @@ --------------------------------- [Installation on DOS (with djgpp), Windows, MacOS (before MacOS X) - and NetWare is described in INSTALL.DJGPP, INSTALL.WIN, INSTALL.MacOS + and NetWare is described in INSTALL.DJGPP, INSTALL.MacOS and INSTALL.NW. This document describes installation on the main supported operating @@ -22,7 +22,8 @@ For more details regarding specific platforms, there are these notes available: - * NOTES.VMS + * NOTES.VMS (OpenVMS) + * NOTES.WIN (any Windows except for Windows CE) Quick Start ----------- @@ -43,6 +44,12 @@ $ mms test $ mms install + on Windows (only pick one of the targets for configuration): + + $ perl Configure { VC-WIN32 | VC-WIN64A | VC-WIN64I | VC-CE } + $ nmake + $ nmake test + [If any of these steps fails, see section Installation in Detail below.] This will build and install OpenSSL in the default location, which is: @@ -50,6 +57,7 @@ Unix: normal installation directories under /usr/local OpenVMS: SYS$COMMON:[OPENSSL-'version'...], where 'version' is the OpenSSL version number ('major'_'minor'). + Windows: currently don't have an install function <TBA> If you want to install it anywhere else, run config like this: @@ -152,6 +160,8 @@ 1a. Configure OpenSSL for your operation system automatically: + NOTE: This is not available on Windows. + $ ./config [options] # Unix or @@ -235,6 +245,13 @@ $ @[PATH.TO.OPENSSL.SOURCE]Configure {target} {options} + Windows example: + + $ C: + $ mkdir \temp-openssl + $ cd \temp-openssl + $ perl d:\PATH\TO\OPENSSL\SOURCE\Configure {target} {options} + Paths can be relative just as well as absolute. Configure will do its best to translate them to relative paths whenever possible. @@ -242,6 +259,7 @@ $ make # Unix $ mms ! (or mmk) OpenVMS + $ nmake # Windows This will build the OpenSSL libraries (libcrypto.a and libssl.a on Unix, corresponding on other platforms) and the OpenSSL binary @@ -268,6 +286,7 @@ $ make test # Unix $ mms test ! OpenVMS + $ nmake test # Windows If some tests fail, look at the output. There may be reasons for the failure that isn't a problem in OpenSSL itself (like a @@ -279,11 +298,15 @@ $ DEFINE HARNESS_VERBOSE YES $ mms test ! OpenVMS + $ set HARNESS_VERBOSE=yes + $ nmake test # Windows + If you want to run just one or a few specific tests, you can use the make variable TESTS to specify them, like this: $ make TESTS='test_rsa test_dsa' test # Unix $ mms/macro="TESTS=test_rsa test_dsa" test ! OpenVMS + $ nmake TESTS='test_rsa test_dsa' test # Windows And of course, you can combine (Unix example shown): @@ -293,6 +316,7 @@ $ make list-tests # Unix $ mms list-tests ! OpenVMS + $ nmake list-tests # Windows Have a look at the manual for the perl module Test::Harness to see what other HARNESS_* variables there are. |