From c44a1b91753e54a9e9381ac6411ec36389d21453 Mon Sep 17 00:00:00 2001 From: Bruno Thomsen Date: Thu, 30 Jul 2020 21:57:46 +0200 Subject: dt-bindings: net: mdio: add reset-post-delay-us property Add "reset-post-delay-us" parameter to MDIO bus properties, so it's possible to add a delay after reset deassert. This is optional in case external hardware slows down release of the reset signal. Signed-off-by: Bruno Thomsen Reviewed-by: Andrew Lunn Reviewed-by: Florian Fainelli Signed-off-by: David S. Miller --- Documentation/devicetree/bindings/net/mdio.yaml | 7 +++++++ 1 file changed, 7 insertions(+) (limited to 'Documentation/devicetree') diff --git a/Documentation/devicetree/bindings/net/mdio.yaml b/Documentation/devicetree/bindings/net/mdio.yaml index d6a3bf8550eb..26afb556dfae 100644 --- a/Documentation/devicetree/bindings/net/mdio.yaml +++ b/Documentation/devicetree/bindings/net/mdio.yaml @@ -39,6 +39,13 @@ properties: and must therefore be appropriately determined based on all devices requirements (maximum value of all per-device RESET pulse widths). + reset-post-delay-us: + description: + Delay after reset deassert in microseconds. It applies to all MDIO + devices and it's determined by how fast all devices are ready for + communication. This delay happens just before e.g. Ethernet PHY + type ID auto detection. + clock-frequency: description: Desired MDIO bus clock frequency in Hz. Values greater than IEEE 802.3 -- cgit v1.2.3