From badb37f1601de0642330125928104e2d19dcc8da Mon Sep 17 00:00:00 2001 From: Paul Cercueil Date: Tue, 19 Mar 2019 15:53:53 +0100 Subject: dt-bindings: mtd: ingenic: Use standard ecc-engine property The 'ingenic,bch-controller' property is now deprecated and the 'ecc-engine' property should be used instead. Signed-off-by: Paul Cercueil Reviewed-by: Rob Herring Signed-off-by: Miquel Raynal --- Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) (limited to 'Documentation/devicetree/bindings/mtd') diff --git a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt index 5a45cc54f46d..c02259353327 100644 --- a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt +++ b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt @@ -14,7 +14,7 @@ Required NAND controller device properties: an offset of 0 and a size of 0x1000000 (i.e. the whole NEMC bank). Optional NAND controller device properties: -- ingenic,bch-controller: To make use of the hardware ECC controller, this +- ecc-engine: To make use of the hardware ECC controller, this property must contain a phandle for the ECC controller node. The required properties for this node are described below. If this is not specified, software ECC will be used instead. @@ -48,7 +48,7 @@ nemc: nemc@13410000 { #address-cells = <1>; #size-cells = <0>; - ingenic,bch-controller = <&bch>; + ecc-engine = <&bch>; nand@1 { reg = <1>; -- cgit v1.2.3