diff options
Diffstat (limited to 'drivers/mtd/spi-nor/spi-nor.c')
-rw-r--r-- | drivers/mtd/spi-nor/spi-nor.c | 140 |
1 files changed, 50 insertions, 90 deletions
diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c index d696334f25f0..06aac894ee6d 100644 --- a/drivers/mtd/spi-nor/spi-nor.c +++ b/drivers/mtd/spi-nor/spi-nor.c @@ -2185,74 +2185,6 @@ static int sr2_bit7_quad_enable(struct spi_nor *nor) return 0; } -/** - * spi_nor_clear_sr_bp() - clear the Status Register Block Protection bits. - * @nor: pointer to a 'struct spi_nor' - * - * Read-modify-write function that clears the Block Protection bits from the - * Status Register without affecting other bits. - * - * Return: 0 on success, -errno otherwise. - */ -static int spi_nor_clear_sr_bp(struct spi_nor *nor) -{ - int ret; - u8 mask = SR_BP2 | SR_BP1 | SR_BP0; - - ret = spi_nor_read_sr(nor, nor->bouncebuf); - if (ret) - return ret; - - nor->bouncebuf[0] &= ~mask; - - return spi_nor_write_sr(nor, nor->bouncebuf, 1); -} - -/** - * spi_nor_spansion_clear_sr_bp() - clear the Status Register Block Protection - * bits on spansion flashes. - * @nor: pointer to a 'struct spi_nor' - * - * Read-modify-write function that clears the Block Protection bits from the - * Status Register without affecting other bits. The function is tightly - * coupled with the spansion_read_cr_quad_enable() function. Both assume that - * the Write Register with 16 bits, together with the Read Configuration - * Register (35h) instructions are supported. - * - * Return: 0 on success, -errno otherwise. - */ -static int spi_nor_spansion_clear_sr_bp(struct spi_nor *nor) -{ - int ret; - u8 mask = SR_BP2 | SR_BP1 | SR_BP0; - u8 *sr_cr = nor->bouncebuf; - - /* Check current Quad Enable bit value. */ - ret = spi_nor_read_cr(nor, &sr_cr[1]); - if (ret) - return ret; - - /* - * When the configuration register Quad Enable bit is one, only the - * Write Status (01h) command with two data bytes may be used. - */ - if (sr_cr[1] & CR_QUAD_EN_SPAN) { - ret = spi_nor_read_sr(nor, sr_cr); - if (ret) - return ret; - - sr_cr[0] &= ~mask; - - return spi_nor_write_sr(nor, sr_cr, 2); - } - - /* - * If the Quad Enable bit is zero, use the Write Status (01h) command - * with one data byte. - */ - return spi_nor_clear_sr_bp(nor); -} - /* Used when the "_ext_id" is two bytes at most */ #define INFO(_jedec_id, _ext_id, _sector_size, _n_sectors, _flags) \ .id = { \ @@ -4634,12 +4566,27 @@ static int spi_nor_setup(struct spi_nor *nor, return nor->params.setup(nor, hwcaps); } +static void atmel_set_default_init(struct spi_nor *nor) +{ + nor->flags |= SNOR_F_HAS_LOCK; +} + +static void intel_set_default_init(struct spi_nor *nor) +{ + nor->flags |= SNOR_F_HAS_LOCK; +} + static void macronix_set_default_init(struct spi_nor *nor) { nor->params.quad_enable = macronix_quad_enable; nor->params.set_4byte = macronix_set_4byte; } +static void sst_set_default_init(struct spi_nor *nor) +{ + nor->flags |= SNOR_F_HAS_LOCK; +} + static void st_micron_set_default_init(struct spi_nor *nor) { nor->flags |= SNOR_F_HAS_LOCK; @@ -4661,6 +4608,14 @@ static void spi_nor_manufacturer_init_params(struct spi_nor *nor) { /* Init flash parameters based on MFR */ switch (JEDEC_MFR(nor->info)) { + case SNOR_MFR_ATMEL: + atmel_set_default_init(nor); + break; + + case SNOR_MFR_INTEL: + intel_set_default_init(nor); + break; + case SNOR_MFR_MACRONIX: macronix_set_default_init(nor); break; @@ -4670,6 +4625,10 @@ static void spi_nor_manufacturer_init_params(struct spi_nor *nor) st_micron_set_default_init(nor); break; + case SNOR_MFR_SST: + sst_set_default_init(nor); + break; + case SNOR_MFR_WINBOND: winbond_set_default_init(nor); break; @@ -4930,21 +4889,26 @@ static int spi_nor_quad_enable(struct spi_nor *nor) return nor->params.quad_enable(nor); } -static int spi_nor_init(struct spi_nor *nor) +/** + * spi_nor_unlock_all() - Unlocks the entire flash memory array. + * @nor: pointer to a 'struct spi_nor'. + * + * Some SPI NOR flashes are write protected by default after a power-on reset + * cycle, in order to avoid inadvertent writes during power-up. Backward + * compatibility imposes to unlock the entire flash memory array at power-up + * by default. + */ +static int spi_nor_unlock_all(struct spi_nor *nor) { - int err; + if (nor->flags & SNOR_F_HAS_LOCK) + return spi_nor_unlock(&nor->mtd, 0, nor->params.size); - if (nor->clear_sr_bp) { - if (nor->params.quad_enable == spansion_read_cr_quad_enable) - nor->clear_sr_bp = spi_nor_spansion_clear_sr_bp; + return 0; +} - err = nor->clear_sr_bp(nor); - if (err) { - dev_dbg(nor->dev, - "fail to clear block protection bits\n"); - return err; - } - } +static int spi_nor_init(struct spi_nor *nor) +{ + int err; err = spi_nor_quad_enable(nor); if (err) { @@ -4952,6 +4916,12 @@ static int spi_nor_init(struct spi_nor *nor) return err; } + err = spi_nor_unlock_all(nor); + if (err) { + dev_dbg(nor->dev, "Failed to unlock the entire flash memory array\n"); + return err; + } + if (nor->addr_width == 4 && !(nor->flags & SNOR_F_4B_OPCODES)) { /* * If the RESET# pin isn't hooked up properly, or the system @@ -5134,16 +5104,6 @@ int spi_nor_scan(struct spi_nor *nor, const char *name, if (info->flags & SPI_NOR_HAS_LOCK) nor->flags |= SNOR_F_HAS_LOCK; - /* - * Atmel, SST, Intel/Numonyx, and others serial NOR tend to power up - * with the software protection bits set. - */ - if (JEDEC_MFR(nor->info) == SNOR_MFR_ATMEL || - JEDEC_MFR(nor->info) == SNOR_MFR_INTEL || - JEDEC_MFR(nor->info) == SNOR_MFR_SST || - nor->info->flags & SPI_NOR_HAS_LOCK) - nor->clear_sr_bp = spi_nor_clear_sr_bp; - /* Init flash parameters based on flash_info struct and SFDP */ spi_nor_init_params(nor); |