diff options
Diffstat (limited to 'arch/arm64/kernel/head.S')
| -rw-r--r-- | arch/arm64/kernel/head.S | 137 |
1 files changed, 19 insertions, 118 deletions
diff --git a/arch/arm64/kernel/head.S b/arch/arm64/kernel/head.S index f2eb206920a2..a0dc987724ed 100644 --- a/arch/arm64/kernel/head.S +++ b/arch/arm64/kernel/head.S @@ -11,7 +11,6 @@ #include <linux/linkage.h> #include <linux/init.h> -#include <linux/irqchip/arm-gic-v3.h> #include <linux/pgtable.h> #include <asm/asm_pointer_auth.h> @@ -21,6 +20,7 @@ #include <asm/asm-offsets.h> #include <asm/cache.h> #include <asm/cputype.h> +#include <asm/el2_setup.h> #include <asm/elf.h> #include <asm/image.h> #include <asm/kernel-pgtable.h> @@ -433,7 +433,7 @@ SYM_FUNC_START_LOCAL(__primary_switched) bl __pi_memset dsb ishst // Make zero page visible to PTW -#ifdef CONFIG_KASAN +#if defined(CONFIG_KASAN_GENERIC) || defined(CONFIG_KASAN_SW_TAGS) bl kasan_early_init #endif #ifdef CONFIG_RANDOMIZE_BASE @@ -493,155 +493,56 @@ SYM_INNER_LABEL(init_el1, SYM_L_LOCAL) eret SYM_INNER_LABEL(init_el2, SYM_L_LOCAL) - mov_q x0, INIT_SCTLR_EL2_MMU_OFF - msr sctlr_el2, x0 - #ifdef CONFIG_ARM64_VHE /* - * Check for VHE being present. For the rest of the EL2 setup, - * x2 being non-zero indicates that we do have VHE, and that the - * kernel is intended to run at EL2. + * Check for VHE being present. x2 being non-zero indicates that we + * do have VHE, and that the kernel is intended to run at EL2. */ mrs x2, id_aa64mmfr1_el1 ubfx x2, x2, #ID_AA64MMFR1_VHE_SHIFT, #4 #else mov x2, xzr #endif + cbz x2, init_el2_nvhe - /* Hyp configuration. */ - mov_q x0, HCR_HOST_NVHE_FLAGS - cbz x2, set_hcr + /* + * When VHE _is_ in use, EL1 will not be used in the host and + * requires no configuration, and all non-hyp-specific EL2 setup + * will be done via the _EL1 system register aliases in __cpu_setup. + */ mov_q x0, HCR_HOST_VHE_FLAGS -set_hcr: msr hcr_el2, x0 isb - /* - * Allow Non-secure EL1 and EL0 to access physical timer and counter. - * This is not necessary for VHE, since the host kernel runs in EL2, - * and EL0 accesses are configured in the later stage of boot process. - * Note that when HCR_EL2.E2H == 1, CNTHCTL_EL2 has the same bit layout - * as CNTKCTL_EL1, and CNTKCTL_EL1 accessing instructions are redefined - * to access CNTHCTL_EL2. This allows the kernel designed to run at EL1 - * to transparently mess with the EL0 bits via CNTKCTL_EL1 access in - * EL2. - */ - cbnz x2, 1f - mrs x0, cnthctl_el2 - orr x0, x0, #3 // Enable EL1 physical timers - msr cnthctl_el2, x0 -1: - msr cntvoff_el2, xzr // Clear virtual offset - -#ifdef CONFIG_ARM_GIC_V3 - /* GICv3 system register access */ - mrs x0, id_aa64pfr0_el1 - ubfx x0, x0, #ID_AA64PFR0_GIC_SHIFT, #4 - cbz x0, 3f - - mrs_s x0, SYS_ICC_SRE_EL2 - orr x0, x0, #ICC_SRE_EL2_SRE // Set ICC_SRE_EL2.SRE==1 - orr x0, x0, #ICC_SRE_EL2_ENABLE // Set ICC_SRE_EL2.Enable==1 - msr_s SYS_ICC_SRE_EL2, x0 - isb // Make sure SRE is now set - mrs_s x0, SYS_ICC_SRE_EL2 // Read SRE back, - tbz x0, #0, 3f // and check that it sticks - msr_s SYS_ICH_HCR_EL2, xzr // Reset ICC_HCR_EL2 to defaults - -3: -#endif - - /* Populate ID registers. */ - mrs x0, midr_el1 - mrs x1, mpidr_el1 - msr vpidr_el2, x0 - msr vmpidr_el2, x1 - -#ifdef CONFIG_COMPAT - msr hstr_el2, xzr // Disable CP15 traps to EL2 -#endif - - /* EL2 debug */ - mrs x1, id_aa64dfr0_el1 - sbfx x0, x1, #ID_AA64DFR0_PMUVER_SHIFT, #4 - cmp x0, #1 - b.lt 4f // Skip if no PMU present - mrs x0, pmcr_el0 // Disable debug access traps - ubfx x0, x0, #11, #5 // to EL2 and allow access to -4: - csel x3, xzr, x0, lt // all PMU counters from EL1 - - /* Statistical profiling */ - ubfx x0, x1, #ID_AA64DFR0_PMSVER_SHIFT, #4 - cbz x0, 7f // Skip if SPE not present - cbnz x2, 6f // VHE? - mrs_s x4, SYS_PMBIDR_EL1 // If SPE available at EL2, - and x4, x4, #(1 << SYS_PMBIDR_EL1_P_SHIFT) - cbnz x4, 5f // then permit sampling of physical - mov x4, #(1 << SYS_PMSCR_EL2_PCT_SHIFT | \ - 1 << SYS_PMSCR_EL2_PA_SHIFT) - msr_s SYS_PMSCR_EL2, x4 // addresses and physical counter -5: - mov x1, #(MDCR_EL2_E2PB_MASK << MDCR_EL2_E2PB_SHIFT) - orr x3, x3, x1 // If we don't have VHE, then - b 7f // use EL1&0 translation. -6: // For VHE, use EL2 translation - orr x3, x3, #MDCR_EL2_TPMS // and disable access from EL1 -7: - msr mdcr_el2, x3 // Configure debug traps - - /* LORegions */ - mrs x1, id_aa64mmfr1_el1 - ubfx x0, x1, #ID_AA64MMFR1_LOR_SHIFT, 4 - cbz x0, 1f - msr_s SYS_LORC_EL1, xzr -1: - - /* Stage-2 translation */ - msr vttbr_el2, xzr - - cbz x2, install_el2_stub + init_el2_state vhe isb + mov_q x0, INIT_PSTATE_EL2 msr spsr_el2, x0 msr elr_el2, lr mov w0, #BOOT_CPU_MODE_EL2 eret -SYM_INNER_LABEL(install_el2_stub, SYM_L_LOCAL) +SYM_INNER_LABEL(init_el2_nvhe, SYM_L_LOCAL) /* * When VHE is not in use, early init of EL2 and EL1 needs to be * done here. - * When VHE _is_ in use, EL1 will not be used in the host and - * requires no configuration, and all non-hyp-specific EL2 setup - * will be done via the _EL1 system register aliases in __cpu_setup. */ mov_q x0, INIT_SCTLR_EL1_MMU_OFF msr sctlr_el1, x0 - /* Coprocessor traps. */ - mov x0, #0x33ff - msr cptr_el2, x0 // Disable copro. traps to EL2 - - /* SVE register access */ - mrs x1, id_aa64pfr0_el1 - ubfx x1, x1, #ID_AA64PFR0_SVE_SHIFT, #4 - cbz x1, 7f - - bic x0, x0, #CPTR_EL2_TZ // Also disable SVE traps - msr cptr_el2, x0 // Disable copro. traps to EL2 + mov_q x0, HCR_HOST_NVHE_FLAGS + msr hcr_el2, x0 isb - mov x1, #ZCR_ELx_LEN_MASK // SVE: Enable full vector - msr_s SYS_ZCR_EL2, x1 // length for EL1. + + init_el2_state nvhe /* Hypervisor stub */ -7: adr_l x0, __hyp_stub_vectors + adr_l x0, __hyp_stub_vectors msr vbar_el2, x0 - isb - mov x0, #INIT_PSTATE_EL1 - msr spsr_el2, x0 + msr elr_el2, lr mov w0, #BOOT_CPU_MODE_EL2 eret |